HP XP P9000 for Business Continuity Manager Software Messages

Table 56 Details of error codes 7Fxx – 8Cxx (continued)
Type of errorError detailsError
code
OthersTHPzPATHCMDCAJCAACABC
• The path between the primary
site and the secondary site is
in the BUSY status.
• The emulation type of the
P-VOL and the S-VOL do not
match. Alternatively, the
number of cylinders in the
S-VOL is less than the P-VOL.
• Either the status of the P-VOL
is being changed, or there is
a copy pair in the group with
the status being changed.
• The command could not be
executed because the specified
CA or CAA volume is in the
SIMPLEX status.
• The S-VOL is not in the
SWAPPING status.
• Either the status of the P-VOL
is being changed, or there is
a copy pair in the group with
the status being changed.
• A copy pair cannot be made
because the same C/T group
ID is set in both the MCU and
RCU.
• The specified C/T group ID is
not registered.
• Alternatively, a path cannot be
defined and deleted because
either the copy pair status or
the parameter is invalid. (The
possible reasons are
documented by error codes
C120 to C12F.)
Not outputOutputNot outputA CAJ copy pair cannot be made.
Possible reasons include one or
both of the following:
8C1E
• The micro version on the
specified primary storage
system does not support a
connection with the specified
secondary storage system.
• The specified primary storage
system does not support a
connection with the specified
secondary storage system.
OutputNot outputThe command could not be
executed because in the
8CE8
instruction to transfer to a remote
DKC, there is an error in the
parameter specification for the
host command.
OutputNot outputThe command could not be
executed because the path for the
8CE9
Details of error codes 205