HP XP P9000 for Business Continuity Manager Software Messages

Table 55 Details of error codes 50xx – 6Exx (continued)
Type of errorError detailsError
code
OthersTHPzPATHCMDCAJCAACABC
command was executed while the
command device was not
defined.
OutputNot outputThe command could not be
executed because it was specified
6A14
to be remotely executed, but this
command cannot be executed as
a remote command.
Not outputOutputNot outputThe command could not be
executed because an instruction
6A16
to delete a command device was
issued against a volume that is not
a command device.
OutputNot outputOutputNot outputThe command cannot be executed
because an un-implemented CU
6A18
number was specified when the
command device was defined or
deleted.
OutputNot outputThe command could not be
executed because a remote
6A19
control command has been
received for a volume that is not
a command device.
OutputNot outputOutputNot outputThe command could not be
executed because the APID
6A1E
specified by the remote command
does not match the APID that was
already registered.
Not
output
OutputNot outputThe setting or status acquisition
command for THPz could not be
6EC0
executed because the specified
parameter is invalid
Not
output
OutputNot outputThe setting or status acquisition
command could not be executed
6EC1
because the command for THPz
contains invalid information, or a
specified value is out of the
supported range.
Not
output
OutputNot outputThe setting or status acquisition
command for THP could not be
6EC2
executed because of either of the
following reasons:
• The volume or pool ID that was
specified does not exist.
• The attribute of the pool that
belongs to the target device is
not THP.
Not
output
OutputNot outputThe setting or status acquisition
command for THP could not be
6EC3
executed due to a parametric
error.
Not
output
OutputNot outputThe setting or status acquisition
command for THP could not be
6EC4
202 Storage system sense byte information