HP XP P9000 for Business Continuity Manager Software Messages

Table 1 Business Continuity Manager error messages and corresponding troubleshooting actions
(message ID YK80x) (continued)
Explanation and recommended actionsMessage textMessage ID
Invalid volumes were detected in the copy group during the
execution of the CLI command cmd. Processing of these volumes
was skipped.
time cmd (RC=4) : Some
volumes with invalid status
found.
YK8223W PRT
CON
time
Message output time
This is only displayed when the output
destination is SYSTSPRT.
type, which was specified for the REPORT parameter, is only valid
for TCA or Cnt Ac-J Z copy groups.
time REPORT type is only
valid for TCA or CAJ Copy
Groups.
YK8230E PRT CON
time
Message output time
This is only displayed when the output
destination is SYSTSPRT.
type
Report type
BCM Monitor could not set the copy group to the specified startup
status.
time BCM Monitor can not
adjust Copy Group status.
YK8231E PRT CON
time
Message output time
This is only displayed when the output
destination is SYSTSPRT.
The message identified by sendmsg appears. The message is
specified in SENDMSG with the STATUS level designated.
time sendmsgYK8300I PRT CON
time
Message output time
This is only displayed when the output
destination is SYSTSPRT.
The action identified by action will be executed because there is a
volume that is not in the status identified by status.
time Not all volumes are in
'status'. action requested.
YK8301I PRT CON
time
Message output time
This is only displayed when the output
destination is SYSTSPRT.
The CLI command identified by cmd will be executed for the copy
group identified by cgid.
time Trying to cmd Copy
Group 'cgid'.
YK8302I PRT CON
time
Message output time
This is only displayed when the output
destination is SYSTSPRT.
BCM Monitor will wait until the copy group being monitored enters
the status identified by status.
time Waiting for status
'status'.
YK8303I PRT CON
time
Message output time
List of messages 19