HP XP P9000 for Business Continuity Manager Software Messages

Table 45 Business Continuity Manager error messages and corresponding troubleshooting actions
(message ID YKZ41x) (continued)
Explanation and recommended actionsMessage textMessage ID
storage system in the disk configuration definition
file. For this reason, a NG scan cannot be executed.
Check the device address domain ID specified in the
disk configuration definition file or the Set Defaults
panel. For details about the NG scan, see the HP XP
P9000 for Business Continuity Manager Software
Reference Guide.
devn (hexadecimal number)
Device number defined in the disk
configuration definition file
sn
Serial number of the storage
system on which the device
indicated by devn actually exists
This storage system does not allow Cnt Ac-S Z data
differential-data management units to be specified.
Copygroup SUPFnc does not support
CA Map (DIF UNIT).
YKZ416E MSG SC=36
RC=36
1
Use a device
2
that allows Cnt Ac-S Z data
differential-data management units to be specified.
Also, if scanning was not performed after the storage
system microcode was replaced, perform another
scan.
SUPFnc (hexadecimal number)
Value for the version of the
storage system support function
used in the copy group (minimum)
1
If this message is output while the YKLOAD
command is being executed, the RC is 44.
2
Units of Cnt Ac-S Z data differential-data
management units can be specified on storage
systems with the following versions of the storage
system support function:
• XP12000/XP10000 disk array
Version of the storage system support function:
X'11' or higher
• XP24000/XP20000 disk array
Version of the storage system support function:
X'20' or higher
The command cannot be executed for Cnt Ac-S Z
copy groups with the HyperSwap attribute.
This command is invalid for CA Copy
Groups linked with HyperSwap.
YKZ417E MSG SC=48
RC=48
Execute the PPRC copy pair operation from TPC-R.
A resynchronization that reverses the copy direction
cannot be performed with the OPENMFUPDATE
OPENMFUPDATE cannot use with
reverse-resync.
YKZ418E MSG SC=48
RC=48
parameter specified. (The OPENMFUPDATE parameter
is used to modify the Open/MF Consistency
attribute.)
The YKQEXCTG command cannot be executed
because the copy group container does not have an
This command is valid only for copy
group containers with EXCTG ID
specified.
YKZ419E MSG SC=48
RC=48
EXCTG ID. This command is valid only for copy
group containers with an EXCTG ID. Confirm that
the command can be executed on the copy group,
and then re-execute the command.
164 Messages