HP XP P9000 for Business Continuity Manager Software Messages

Table 44 Business Continuity Manager error messages and corresponding troubleshooting actions
(message ID YKZ91x) (continued)
Explanation and recommended actionsMessage textMessage ID
Use a device which supports the parameter indicated
by param. Also, if a scan has not been performed
after the storage system microcode was replaced,
perform another scan.
param (string)
The parameter name which is not
supported
The copy pair entered an unexpected status while
registering the journal group to EXCTG.
Unexpected transition occurred while
adding JNLG to EXCTG. (CT ID=jj,
YKZ402E MSG SC=44
RC=44
Check that the status to be monitored is correctly
specified. If the status is correctly specified, execute
sub CT ID=kk, MIRROR=m,
SN=ssssssssssss, STATE=nnnn)
the YKQUERY command to determine the cause of
the problem and rectify the error.
jj (hexadecimal number)
The journal group number
specified by the C/T group ID
(00-FF)
kk (hexadecimal number)
The journal group number
specified by the sub C/T group
ID (00-FF)
m (decimal number)
Mirror ID (0-3)
ssssssssssss (decimal number)
Storage system serial number
nnnn (string)
The status after the transition
The target copy pair was not found.No pair processed in Copy Groups.YKZ403I MSG SC=0
RC=0
Check the volume status, correct errors involved in
the configuration or execution conditions if any, and
then re-execute the command.
If the YKMAKE SELECT(COND) command is issued
on a copy group container with EXCTG ID specified
but without specifying the DEVN parameter, the
EXCTG registration I/O is issued even if this message
is output.
The number of journal groups in the EXCTG
exceeded the maximum number allowed.
Number of JNLG in the EXCTG
exceeds the limit.
YKZ404E MSG SC=36
RC=36
1
1
If this message is output while the YKLOAD
command is being executed, the RC is 44.
Duplicate journal group numbers were found in the
copy group.
Duplicate JNLG number in the Copy
Group is found. (CT ID=jj, sub CT
ID=kk)
YKZ405E MSG SC=36
RC=36
1
In order to make the journal group pairs over multiple
storage systems correspond to copy groups which
configure a container, use different numbers in one
of the pairs of C/T group ID and sub C/T group ID
which describe the journal group number.
jj (hexadecimal number)
156 Messages