HP XP P9000 for Business Continuity Manager Software Messages

Table 43 Business Continuity Manager error messages and corresponding troubleshooting actions
(message ID YKZ3x) (continued)
Explanation and recommended actionsMessage textMessage ID
The specified error code is invalid. A possible cause
is as follows:
• The specified value is not a four-digit hexadecimal
value.
The specified error code is invalid.YKZ352E TSO RC=16
The load module cannot be found. Possible causes
are as follows:
Load module is not found.YKZ353E TSO RC=64
• The library dataset has not been concatenated.
• The module is protected by the RACF program
control function.
A description for the specified error code was not
found.
A description for the specified error
code was not found.
YKZ354I TSO RC=8
For details on error codes, see “Storage system sense
byte information” (page 171). If the error code is not
listed in the manual, contact maintenance personnel.
A dynamic change in an I/O configuration definition
was detected during processing of the command.
A dynamic configuration change was
detected during specified command
processing. DEVN device#
YKZ370E MSG SC=32
RC=32
Check the status of the device targeted by the
command, correct any errors related to the
configuration or execution conditions, and then
re-execute the command.
device#
Device number being processed
when a dynamic change was
detected in an I/O configuration
definition
The YKENV command terminated.YKENV command return
code=return-code.
YKZ371I TSO
return-code
Return code issued by the YKENV
command
Table 44 Business Continuity Manager error messages and corresponding troubleshooting actions
(message ID YKZ91x)
Explanation and recommended actionsMessage textMessage ID
The parameter indicated by param cannot be
specified for a copy group with a copy type of
copy-type.
param parameter cannot be
specified for copy-type Copy Group.
YKZ400E MSG SC=48
RC=48
Check the copy type and the parameter.
param (string)
The parameter name which
cannot be specified
copy-type (string)
The copy type specified for the
copy group
The storage system which the command is issued
onto, or the storage system which uses the remote
Some of the storage systems do not
support param.
YKZ401E MSG SC=48
RC=48
DKC control function, does not support the parameter
indicated by param.
List of messages 155