HP XP P9000 for Business Continuity Manager Software Messages

Table 42 Business Continuity Manager error messages and corresponding troubleshooting actions
(message ID YKZ29x) (continued)
Explanation and recommended actionsMessage textMessage ID
The version of this configuration file is not supported.The version of this configuration file
is not supported.
YKZ295E MSG SC=36
RC=36
The journal group is not registered in EXCTG for the
storage system.
A JNLG is not registered in EXCTG.
(JNLG=jj, MIRROR=m, EXCTG=e,
SN=ssssssssssss)
YKZ296E MSG SC=44
RC=44
The journal group might not be registered in EXCTG
because the YKMAKE command has not been
executed for EXCTG, or an error occurred during the
execution of the YKMAKE command. Alternatively,
the journal group might be dissolved from EXCTG
registration by executing the YKRECVER command.
Remove the cause of the problem if the YKZ297E
message is output during the execution of the
YKEWAIT or YKQUERY command after executing the
YKMAKE command for EXCTG. Then execute the
YKMAKE command again with a SELECT(COND)
specification to register the journal group in EXCTG
for the storage system.
Note that, to register an existing journal group in
EXCTG, you need to execute the YKQUERY command
before executing the YKMAKE command with a
SELECT(COND) specified. In this case, the YKZ296E
message will appear until the registration has
completed normally.
Also, if you execute the YKQUERY command to obtain
the status while a copy pair in EXCTG is dissolved,
the YKZ296E message sometimes appears when the
dissolving of the copy pair is detected at a different
time from the dissolving of EXCTG, but this does not
mean that an error has occurred. In this case, wait
until the copy pair status changes to SIMPLEX, and
then re-execute the YKQUERY command. The message
will no longer appear.
In 4x4x4 Delta Resync configurations, when all copy
pairs in EXCTG whose copy direction is from the
primary site to the remote site are dissolved, the
journal groups whose copy direction is from the local
site to the remote site are also dissolved from EXCTG
registration. For example, if a Delta Resync is
executed and then the YKDELETE command is
executed when EXCTG is in the HOLD status and the
copy direction is from the primary site to the remote
site, the journal groups whose status is DUPLEX and
copy direction is from the local site to the remote site
are dissolved from EXCTG registration. As a result,
the YKZ296E message is output if the YKQUERY
command is executed to obtain the status of Universal
Replicator copy pairs whose copy direction is from
the local site to the remote site. In this case, perform
either of the following operations to register journal
groups in EXCTG for the storage system:
• Execute the YKMAKE HOLD command for
Universal
Replicator copy pairs whose copy direction is
from the primary site to the remote site.
• Execute the YKMAKE command with a
SELECT(COND) specified for Universal Replicator
copy pairs whose copy direction is from the local
site to the remote site.
List of messages 149