HP XP P9000 for Business Continuity Manager Software Messages

Table 37 Business Continuity Manager error messages and corresponding troubleshooting actions
(message ID YKZ21x – YKZ24x) (continued)
Explanation and recommended actionsMessage textMessage ID
ATTIME or CANCEL is specified together with SVOL.Supplied parameters invalidYKZ243E MSG SC=48
RC=48
Correct the YKSUSPND command parameter values,
and then re-execute the command.
The specified storage system does not exist in the
route list.
Storage system serial-number is not
found in Routelist.
YKZ244E MSG SC=36
RC=36
serial-number
Storage system serial number
The combination of the specified command or the
operand, and copy group attribute is invalid.
CopyGroup attribute combination is
invalid.
YKZ245E MSG SC=48
RC=48
Check the configuration file to make sure that the
configuration allows command execution, and
execute the command again.
This operation is not supported when a remote
function is in use.
This operation (operation) does not
support remote command.
YKZ246E MSG SC=48
RC=48
operation
Operation name
Information on the specified stem name is missing.STEM(stem) information for Core
Processing is not found.
YKZ247E MSG SC=44
RC=44
The YKLOAD command has not been executed or the
stem name does not match the stem name specified
for the YKLOAD command.
stem
Stem name
Certain information required for CLI command
execution has not been registered.
Necessary information for Core
Processing is not stored. (STEM =
stem)
YKZ248E MSG SC=44
RC=0
Execute the YKLOAD command to register the
information.
stem
1
Stem name
1
The (STEM = stem) portion is displayed only when
the stem is obtained.
The DAD or ROUTE parameter specified on the
YKLOAD command is invalid.
Specified DAD or ROUTE is invalid.YKZ249E MSG SC=48
RC=48
1
(pair-index)
Correct the specification.
pair-index
See the pair index description in
the explanation of the YKE003E
message.
1
If this message is output while the YKLOAD
command is being executed, the RC is 44.
List of messages 133