HP XP P9000 for Business Continuity Manager Software Messages

Table 28 Business Continuity Manager error messages and corresponding troubleshooting actions
(message ID YKX1x) (continued)
Explanation and recommended actionsMessage textMessage ID
The specified parameter combination is invalid.Parameter combination is invalidYKX103E MSG SC=48
For details about the combination of parameters, see
the description of the YKBLDCMD command or the
YKDELCMD command in the HP XP P9000 for Business
Continuity Manager Software Reference Guide.
The device specified in the DEVN parameter does not
exist, or a device other than DASD or a PAV ALIAS
volume has been specified.
Device# DEVN() is not foundYKX104E MSG SC=48
The value specified in the APID parameter is not in
hexadecimal format.
APID() not valid hexYKX108E MSG SC=48
The value specified in the CCA parameter is not in
hexadecimal format.
CCA() not valid hexYKX108E MSG SC=48
The value specified in the CU parameter is not in
hexadecimal format.
CU() not valid hexYKX108E MSG SC=48
The value specified in the DEVN parameter is not in
hexadecimal format.
DEVN() not valid hexYKX108E MSG SC=48
Access to the REXX variable identified by name failed.REXX failure return code=nnnn
starting with variable name
YKX110E TSO RC=40
For details about the return code, see IKJCT441 in the
TSO/E Programming Services.
nnnn
Error code returned upon REXX
access
The route list to be processed was not found.Necessary Route List is not found.YKX166E MSG SC=48
Review the ROUTE and DAD parameters, route list
definition file, and command device definition file you
specified when executing the YKLOAD command.
The YKDELCMD command terminated with the return
code nnnn and the reason code rrrr.
YKDELCMD command return
code=nnnn, reason code=rrrr
YKX199I TSO
Table 29 Business Continuity Manager error messages and corresponding troubleshooting actions
(message ID YKX2x)
Explanation and recommended actionsMessage textMessage ID
Invalid parameters are specified.Supplied parameters invalidYKX200T TSO RC=48
For details, see the reason code in the YKX299I
message that will appear after this message. For
reason codes, see IKJPARS in the TSO/E Programming
Services.
Nothing is assigned to the CCA parameter.No command control address
CCA() supplied
YKX201E MSG SC=48
Nothing is assigned to the CU parameter.No control unit# CU() suppliedYKX201E MSG SC=48
Nothing is assigned to the DEVN parameter.No device# DEVN() suppliedYKX201E MSG SC=48
Nothing is assigned to the MSG parameter.No message MSG() suppliedYKX201E TSO RC=48
Nothing is assigned to the SMODEL parameter.No model SMODEL() suppliedYKX201E MSG SC=48
Nothing is assigned to the STEM parameter.No results STEM() suppliedYKX201E MSG SC=48
102 Messages