HP XP P9000 Continuous Access Synchronous for Mainframe Systems User Guide

DescriptionError code
(SSB2)
The command was rejected because the specified volume is used as an S-VOL.C297
The pair cannot be created because the capacity that is used by software products other than Cnt Ac-S Z
exceeds license capacity.
C2A0
The command was rejected because an internal logical error has occurred.C2A1
The pair cannot be created because the used capacity exceeds the license capacity.C2A3
The command was rejected because THP V-VOL capacity is changing.C2B3
The command was rejected because an internal logical error has occurred.C2B4
The pair cannot be created because the Cnt Ac-S Z P-VOL is being initialized by Business Copy.C2B5
The command was rejected because the releasing pages in THP V-VOL is in progress.C2B6
The Cnt Ac-S Z pair associated with a Cnt Ac-J Z pair cannot be added because the Cont Access Journal
3DC & 4x4 Open MF program product is not installed on the main system.
C300
The Cnt Ac-S Z pair associated with a Cnt Ac-J Z pair cannot be added because the Cont Access Journal
3DC & 4x4 Open MF program product is not installed on the remote system.
C301
The pair cannot be created because the S-VOL is a THP V-VOL.C304
The pair cannot be created because the capacity that is used by Cnt Ac-S Z in the secondary system exceeds
license capacity. Check license capacity, including for related software products.
C305
The volume in the secondary system or another volume that belongs to the same group is changing to Simplex
or Suspend status. Retry the operation after several minutes.
C30D
The NVS is not ON in the MCU.C310
The storage system level cache is not valid in the MCU.C311
The P-VOL is not in Simplex status.C312
The P-VOL is not in Suspended or Suspended status.C313
The P-VOL is not in Simplex status.C314
The P-VOL includes PIN data.C315
The P-VOL is in the process of drive copy for failure assistance.C316
The P-VOL is in the process of drive copy for an SVP request.C317
The P-VOL is terminating the copy task.C318
The P-VOL is in the process of collection copy.C319
The P-VOL is in the process of collection access.C31A
The P-VOL is blocked.C31B
The P-VOL is blocked and impossible to access.C31C
The P-VOL is being formatted.C31D
The P-VOL is read only.C31E
The number of primary-secondary system logical paths is 0 (not specified).C320
The number of primary-secondary system logical paths is smaller than the minimum required.C321
The DKC type of the main system does not support Cnt Ac-S Z.C322
The remote system’s sequence number, SSID, or CU are invalid.C324
The NVS is not ON in the RCU.C325
Troubleshooting using RAID Manager 97