HP XP P9000 Continuous Access Synchronous for Mainframe Systems User Guide

DescriptionError code
(SSB2)
A request for a Pairsplit-r operation was rejected because the corresponding volume or group was changing
status.
C199
The pair’s status cannot be changed during the power-on processing of the DKC.C1BE
The command was rejected because the specified volume is a P-VOL. If the error occurs when the volume
is in Simplex status, select the volume in Remote Web Console, release the pair using the Yes option for
Delete Pair by Force in the Pairsplit-S dialog box, and then run the command again.
C211
The command was rejected because the specified volume is an S-VOL. If the error occurs when the volume
is in Simplex status, select the volume in Remote Web Console, release the pair using the Yes option for
Delete Pair by Force in the Pairsplit-S dialog box, and then run the command again.
C212
The command was rejected because the secondary system is not registered, or the registered information
is invalid.
C214
The command was rejected because an internal logical error has occurred.C215
The command was rejected because the pair status is invalid.C218
The command was rejected because the P-VOL status is not Suspended, Suspended, or PDUB.C21A
The command was rejected because the secondary system is not registered, or the registered information
is invalid.
C21C
The command was rejected because the pair release was run on a volume other than P-VOL.C22A
The command was rejected because the volume status is Simplex.C22C
The command was rejected because the specified volume is the volume other than the P-VOL.C22D
The command was rejected because the pairsplit command specifying -P option (write protection of P-VOL)
was issued to a volume whose status is not Duplex.
C22E
The command was rejected because the S-VOL status is Simplex.C233
The command was rejected because an internal logical error has occurred.C234/
C235/
C236/
C237
The command was rejected because the specified volume is the volume other than the P-VOL.C238
The command was rejected because the pair resync was operated on a volume whose status is other than
Suspended, Suspended, or PDUB.
C239
The command was rejected because an internal logical error has occurred.C23A
The command was rejected because the volume status is Simplex.C23B
The command was rejected because the volume status is other than Duplex or Pending.C23C
The command was rejected because the command for Cnt Ac-S Z asynchronous was issued to the Cnt Ac-S
Z asynchronous volume.
C23D
The pair cannot be created because the command was issued to the command device.C267
The command was rejected because the specified consistency group number is invalid.C271
The command was rejected because the takeover command was issued to a volume whose status is not
SSWS.
C28B
The command was rejected because the secondary system is not registered, or the registered information
is invalid.
C28C
There is no volume to which the takeover command can run.C28D
The command was rejected because an internal logical error has occurred.C28E
96 Troubleshooting