HP XP P9000 Continuous Access Synchronous for Mainframe Systems User Guide

Error codes appear on the right of the equal symbol (=).
Review RAID Manager error codes in the following topics.
• “SSB2 error codes when SSB1 = 2E31/B901/B90A/B90B/B912/D004” (page 94)
• “SSB2=B992 error codes when SSB1 = B901 or B90A” (page 102)
SSB2 error codes when SSB1 = 2E31/B901/B90A/B90B/B912/D004
DescriptionError code
(SSB2)
The pair cannot be suspended because of one of the following conditions:47A3
• Write access permitted in the S-VOL is unsupported.
• The Swap Suspend is unsupported.
The pair cannot be created because the specified P-VOL is one of the following:47BA
• Used as an BC Z S-VOL.
• Intervention-required or protected.
The pair cannot be created because the specified P-VOL belongs to a different CLPR than the registered
consistency group CLPR.
4A96
A pair cannot be resynchronized because the specified consistency group does not have the Open/MF
attribute.
4B02
The pair cannot be created because the specified P-VOL is defined as the command device.4B04
The pair cannot be resynchronized because the specified volume is in failover in PPRC.4B22
The pair cannot be suspended because the specified volume is in failover in PPRC.4B23
A request for a pair operation (Paircreate/pair suspension/Pairresync/Pairsplit-S) was rejected because the
online microcode is being replaced.
4B2F
The pair cannot be created because the specified P-VOL is one of the following:4B32
• Used by Compatible FlashCopy
• Used by Compatible FlashCopy SE
• A TSE volume
A request for a Paircreate or Pairresync operation to the consistency group was rejected because the specified
P-VOL is a Compatible FlashCopy S-VOL.
4B85
A request for a Paircreate or Pairresync (managed by cylinder) operation was rejected because the specified
P-VOL is fa Compatible FlashCopy S-VOL.
4B86
A request for a Paircreate operation (Time Stamp mode) was rejected because the specified volume is
already used in Compatible XRC.
4BB2
The command cannot be executed because the user authentication is not performed.9100
A request for a Paircreate or Pairresync operation to the consistency group was rejected because supported
and unsupported microcodes are used in the DKC.
B923
You cannot run the following operations to a pair in a 2DC configuration:B927
Swap Suspend
Takeover
The pair cannot be created because the Mirror ID is invalid.B928
94 Troubleshooting