HP XP P9000 Continuous Access Synchronous for Mainframe Systems User Guide

DescriptionError code
(SSB2)
S-VOL pair status is not Suspended or Suspended.C3DB
Cnt Ac-S, Cnt Ac-S Z, Cnt Ac-J, and Cnt Ac-J Z cannot be mixed in the consistency group.CB12
The remote system consistency group cannot be deleted because the Takeover command reversing operations
between the P-VOL and S-VOL failed.
CB19
The remote system consistency group was abnormally terminated because the Takeover command reversing
operations between the P-VOL and S-VOL failed.
CB1A
No dummy volume can be created in the S-VOL.CB1D
The remote system does not support Cnt Ac-S Z.CB1F
In referring to the function bit, the system information reference was abnormally terminated.CB20
In a Pairresync operation, all difference setting was abnormally terminated.CB21
An internal error occurred.CB23
The pair cannot be created because the specified P-VOL is in an older model storage system and unsupported.CB5D
If the path is set between CUs, LUSE pairs with different CUs cannot be created.CB5F
Cnt Ac-S Z is not installed in the remote system.CB60
The required differential area is not available in the remote system.CB66
An additional shared memory is not installed in the remote system.CB67
The required differential area is not available in the main system.CB68
The number of pairs exceeds the maximum number that can be created in a single consistency group.CB69
The Add Pair operation cannot run because the P-VOL is an external storage system volume.CB6E
The Add Pair operation cannot run because the S-VOL is an external storage system volume.CB6F
The Add Pair operation cannot run because the P-VOL is an external storage system migration volume.CB71
The Add Pair operation cannot run because the S-VOL is an external storage system migration volume.CB73
The device is not recognized correctly.CB75
The Add Pair operation cannot run because the paths are specified per storage system.CB76
The used capacity of the Volume Retention software product on the remote system exceeds the license
capacity.
CB77
The Add Pair operation cannot run because the specified S-VOL is defined as the command device.CB78
A request for an Add Pair operation was rejected because the specified S-VOL belongs to a different CLPR
than the registered consistency group’s CLPR.
CB7E
The pair cannot be added because the specified S-VOL does not support the time stamp transfer mode.CB9E
The Add Pair operation cannot run because the S-VOL LUN of S-VOL is a LUSE volume created across
multiple CLPRs.
CBD1
The storage system is in internal processing. Try the operation again.CBD7
A pair cannot be created because the specified main volume is one of the following:CBD8
• A journal volume used for Cnt Ac-J Z.
• A Cnt Ac-J Z remote volume that is in a status other than Suspend.
The pair cannot be added because the specified S-VOL is used for Compatible FlashCopy or Compatible
FlashCopy SE, or is the TSE volume.
CBD9
Troubleshooting using RAID Manager 101