HP XP P9000 Business Continuity Manager User Guide (T5253-96086, November 2013)

| |
| C/T ID . . . . . . . (2-digit Hexadecimal) |
| COPY PACE . . . . . . NORMAL (NORMAL or SLOW) |
| PROT MODE . . . . . . PERMIT (PROTECT or PERMIT) |
| Preset Mode . . . . . 1 1.NORMAL |
| 2.CAJ(STEADY) |
| 3.CAJ(QUICK) |
| |
| F1=Help F12=Cancel |
'------------------------------------------------------------------'
8. Press the Enter key.
The Copy Group Pair Detail panel appears.
Adding the copy pair to the copy group (Business Copy Z)
The operations for adding a copy pair to a Business Copy Z copy group are the same as those in
“Adding the copy pair to the copy group (Continuous Access Journal Z)” (page 648).
Defining the copy group ID and copy group attributes (Continuous Access Synchronous
Z)
To define a Continuous Access Synchronous Z copy group:
1. Display the Discover/Define Configuration panel and choose 4 Copy Group Definitions.
The Copy Group Selection List panel displays.
2. Press the F5=Add key to add a Continuous Access Synchronous Z copy group.
The Add Copy Group panel displays.
3. Specify the Copy Group ID, Device Address Domain (for both Primary and Secondary), and
Copy Group Type (CA).
.------------------------------------------------------------------.
| Add Copy Group |
| Command ===> |
| |
| Copy Group ID . . . GRP1 |
| Device Address Domain, |
| Primary . . . . . DADP |
| Secondary . . . . DADS |
| Copy Group Type . . CA Use Container |
| |
| Double check Device Address Domain ID values before proceeding. |
| Press Enter to create the Copy Group, Cancel to cancel. |
| |
| F1=Help F12=Cancel |
'------------------------------------------------------------------'
4. Press the Enter key.
The Setting C/T ID Attributes panel displays.
5. Press Enter key to close the Setting C/T ID Attributes panel (for Continuous Access Synchronous
Z, C/T ID (JNLG) is optional).
The Copy Group Pair Detail panel appears (in the initial state, no list of copy pairs appears
because no copy pair is defined at this point).
6. Press the F4=Attr key.
The Copy Group Attributes (CA) panel appears.
652 Using the ISPF panels