HP XP P9000 Business Continuity Manager User Guide (T5253-96086, November 2013)

Table 52 How to Prepare the Configuration Files at Each Site (3DC Multi-Target (Cnt Ac-S Z x Cnt
Ac-J Z) configuration) (continued)
How to PrepareContentsFile Type
At the Secondary SiteAt the Local SiteAt the Primary Site
Not requiredNot requiredDefine a path setPath set definition file
• An inter-control unit
logical path from
the primary site to
the local site
• An inter-disk
controller logical
path from the
primary site to the
remote site
Not requiredDefine a path setNot requiredAn inter-control unit
logical path from the
local site to the
primary site
Define a path setNot requiredNot requiredAn inter-disk controller
logical path from the
remote site to the
primary site
Not requiredNot requiredDefine a route listRoute list definition
file/Command
device definition file
• A route/command
device from the
primary site to the
local site
• A route/command
device from the
primary site to the
remote site
Not requiredDefine a route listNot requiredA route/command
device of Local →
Primary → Remote
Define a route listNot requiredNot requiredA route/command
device of Remote →
Local → Primary
Transfer from the
primary site
Transfer from the
primary site
Define a copy groupA Continuous Access
Synchronous Z copy
group
Copy group
definition file
Define a copy groupA Continuous Access
Journal Z copy group
NOTE: If you define the route list, the route list definition file and the command device definition
file will be created at the same time.
Definition Procedure (3DC Multi-Target (Cnt Ac-S Z x Cnt Ac-J Z) Configuration)
First, set the items that need to be set by using Remote Web Console from among the items listed
in Table 49 (page 175).
This section explains the definition of a 3DC Multi-Target (Cnt Ac-S Z x Cnt Ac-J Z) configuration
as shown in the ISPF panel.
The following explains the legend for the figures used for the operation procedures described in
this section:
178 Configuration definitions