HP XP P9000 Business Continuity Manager User Guide (T5253-96086, November 2013)

• Usable: The target site can be used.
Unusable: The target site cannot be used because of an error.
• # Required only if the Continuous Access Synchronous Z Consistency Preservation Function
is used.
Table 42 (page 154) shows how to prepare the configuration files at each site.
Table 42 How to Prepare the Configuration Files at each site (3DC Cascade (Cnt Ac-S Z x Cnt Ac-J
Z) Configuration)
How to PrepareContentsFile Type
At the Secondary SiteAt the Primary Site
Perform a remote scanPerform a local scanThe primary site
configuration
Disk configuration
definition file
Perform a remote scanPerform a remote scanThe intermediary site
configuration
Perform a local scanPerform a remote scanThe remote site configuration
Not requiredDefine a path setPath set definition file
• An inter-control unit
logical path from the
primary site to the
intermediate site
• An inter-disk controller
logical path from the
intermediate site to the
remote site
Define a path setNot required
• An inter-control unit
logical path from the
intermediate site to the
primary site
• An inter-disk controller
logical path from the
remote site to the
intermediate site
Not requiredDefine a route listA route/command device
from the primary site, to the
Route list definition
file/Command device
definition file intermediate site, and then
the remote site
Define a route listNot requiredA route/command device
from the remote site, to the
intermediate site, and then
the primary site
Transfer from the primary
site
Define a copy groupA Cnt Ac-S Z copy groupCopy group definition file
Define a copy groupA Cnt Ac-J Z copy group
NOTE: If you define the route list, the route list definition file and the command device definition
file will be created at the same time.
Definition procedure (3DC Cascade (Cnt Ac-S Z x Cnt Ac-J Z) configuration)
First, set the items that need to be set by using Remote Web Console from among the items listed
in Table 39 (page 152).
This section explains how to set up a 3DC Cascade (Cnt Ac-S Z x Cnt Ac-J Z) configuration from
the ISPF panel.
154 Configuration definitions