HP XP P9000 Audit Log User and Reference Guide

DescriptionItem
The time when the time correction function is executed. Only HH (Hour: 00 to 23) is indicated
for the execution time.
Check Time
Indicates whether the SIM was created or not when the setting of time correction failed.Create SIM
ON: Created, OFF: Not created.
[Install] Set UserAuth
Example
07xx, YYYY/MM/DD,HH:MM:SS.xxx, 00:00,SVP,uid=user-name,1,,
[Install],Set UserAuth,,Normal end,
from=xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx,,Seq.=xxxxxxxxxx
+{LDKC:CU:LDEV,UserAuth}=[{0xXX:0xXX:0xXX,Enable}],
Num. of LDEVs=1
Detailed information
DescriptionItem
The LDKC, CU, and LDEV numbers of the volume where the user authentication is specified.LDKC:CU:LDEV
Indicates whether the user authentication is enabled or disabled.UserAuth
Disable or Enable will appear.
The number of logical volumes where the user authentication is set.Num. of LDEVs
[Install] System Option
Example
07xx,YYYY/MM/DD,HH:MM:SS.xxx, 00:00,SVP,uid=user-name,1,,
[Install],System Option,,Normal end,
from=xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx,,Seq.=xxxxxxxxxx
+Spare Disk Recover=Full Speed
+Disk Copy Pace=Slower
+Copy Operation(Correction Copy)=OFF
+Copy Operation(Dynamic Sparing)=OFF
+Read Configuration Data Mode=OFF
+Link Failure Threshold=10
+{LDKC:CU:LDEV,Destage}=[{0x00:0x00:0x00,OFF}],
Num. of LDEVs=1
+{LPR,Cache Tuning}=[{System,Level5}],Num. of LPRs=1
+{LPR,Command Control}=[{System,10}],Num. of LPRs=1
+{LPR,Mode,Set}=[{System,0,ON}],Num. of Modes=1
+Debug Mode=Set
Detailed information
DescriptionItem
Indicates the setting status of Spare Disk Recover.Spare Disk Recover
Interleave: Give priority to the access from the host while executing copy process, Full speed:
Give priority to the copy process.
Indicates the setting status of Disk Copy Pace.Disk Copy Pace
Slower: Low speed, Medium: Medium speed, Faster: High speed
Indicates the setting status of Copy Operation (Correction Copy).Copy Operation
Install descriptions 101