HP StorageWorks P9000 Data Exchange User Guide (T1620-96016, September 2010)
7. When the format operation completes successfully, the Format complete message is displayed
(see Figure 59 on page 99).
Figure 59 FMT Format Complete Message
.
If the specified volser has already been used, an error message is displayed to notify you (see
Figure 60 on page 99).
Figure 60 FMT VOLSER Used Message
.
If the format operation could not be started due to an error condition, the Format check error
message is displayed.
Figure 61 FMT Error Message
.
If the format operation did not complete successfully, one of the following error messages is
displayed (see Figure 61 on page 99) (n = system error code):
Open error! (n): Open process error on specified volume.
Seek error! (n): Seek process error on specified volume.
Read error! (n): Read process error on specified volume.
Write error! (n): Write process error on specified volume.
Close error! (n): Close process error on specified volume.
8. When you are finished formatting OPEN-x volumes for use as FXoto volumes, click Close to close
the Format panel and exit the FMT utility.
HP StorageWorks P9000 Data Exchange User Guide 99