HP StorageWorks P9000 Data Exchange User Guide (T1620-96016, September 2010)

NOTE:

There is no guarantee that Data Exchange will correctly access your data without meeting these

requirements.

Table 28 Support and OS Conditions

Data Exchange Ver-

sion

Storage SystemOS Version

01–03–59 and laterXP24000/XP20000 or XP12000/XP10000 disk arrayVSE2.5 and later

When you use MTO and OTM for the dataset allocated by VSE 2.3, you must specify the RF , RL and

BL by using the correct VSE parameters.

When you use MTO and OTM for the dataset allocated by VSE 2.5, Data Exchange can transfer

data without a VSE parameter.

Table 29 Support Matrix for VSE OS, VSE Parameter and Record Format

Record Format

VSE ParameterOS and Data

Exchange Ver-

sion

VBVFBF

AvailableAvailableAvailableAvailableYesVSE 2.3 and

earlier

(Data Exchange

01-xx-58 and

earlier)

Not availableNot availableNot availableNot availableNo

Available

AvailableAvailableYes

VSE 2.5 and

later

(Data Exchange

01-03-59 and

later)

Available

AvailableAvailableNo

Legend:

F: Fixed non-block length

FB: Fixed block length

V: Variable non-block length

VB: Variable block length

It is possible to transfer data between correct dataset attribute (5 RL BL 4). The data transfer is

valid only if the VSE parameters are as shown:

RL 32756

BL 32760

BL=RL+4

For the following dataset attributes, the data transfer is invalid if user does not specify the VSE

parameter value as shown above.

RL>32756

HP StorageWorks P9000 Data Exchange User Guide 51