HP StorageWorks P9000 Data Exchange Code Converter User Guide (T1620-96017, September 2010)

3 System Requirements and Installation
This chapter describes the system and installation requirements for Code Converter. It also details
how to install Code Converter on your system.
• System Requirements, page 29
• Overview of the Data Exchange Code Converter Installation, page 30
• Installation Media for UNIX-based Systems, page 30
• Installation Media for Windows-based Systems, page 32
• Installing and Uninstalling for UNIX Systems, page 33
• Installing and Uninstalling for Windows Systems, page 34
• License Key Input, page 35
System Requirements
The system requirements for the Data Exchange Code Converter are:
• FAL/FCU CD for the applicable open-system platform(s). See the HP StorageWorks P9000 Data
Exchange Software (32-bit) v67.06 Release Notes or HP StorageWorks P9000 Data Exchange
Software (64-bit) v67.06 Release Notes for details regarding the FAL/FCU software.
NOTE:
FAL/FCU currently supports files larger than 2 GB.
• Multiplatform or all-open P9500 Disk Array storage systems:
• Data Exchange Code Converter mto: the P9500 Disk Array must be configured with -B and/or
-A Data Exchange volumes.
• Data Exchange Code Converter otm: the P9500 Disk Array must be configured with -C and/or
-A Data Exchange volumes.
NOTE:
A license key is required for Data Exchange Code Converter operation. If you execute mto before
inputting the license key code, a 0 byte file will be created. If this occurs, execute mto again after
you have input the license key code. The Remote Console − HP StorageWorks P9000 Remote
Web Console is used to enter the license key. For information on the Remote Console − Remote
Web Console, see the HP StorageWorks P9000 Remote Web Console User's Guide .
• See the release notes for supported operating systems.
• Data Exchange Code Converter works with Data Exchange software version 01-03-56 or later.
P9000 Data Exchange Code Converter User Guide 29