HP P9000 Business Continuity Manager User Guide

Format
If both the name of the cataloged procedure for startup and the identification name were specified
in the START command:
MODIFY
Δ1cataloged-procedure-for-startup-name.]identification-name
,SETΔ1{CYLCETIME=cycle-time|
WAITTIMEOUT=timeout-value|
MONITOR=[START|STOP],CGID=copy-group-id|
MSGLEVEL=SYSTSPRT-message-level,console-message-level}
If only the name of the cataloged procedure for startup was specified in the START command.
MODIFY
Δ1cataloged-procedure-for-startup-name
,SETΔ1{CYLCETIME=cycle-time|
WAITTIMEOUT=timeout-value|
MONITOR=[START|STOP],CGID=copy-group-id|
MSGLEVEL=SYSTSPRT-message-level,console-message-level}
Operands
cataloged-procedure-for-startup-name
Used to specify the name of the cataloged procedure for startup that was specified in the START
command when Business Continuity Manager Monitor was started.
identification-name
Used to specify the identification name that was specified in the START command when Business
Continuity Manager Monitor was started.
SET
Changes the values specified in the Business Continuity Manager Monitor parameter files after
Business Continuity Manager Monitor has started. The values to be changed are specified by the
suboperands shown below. The changed values take effect from the next cycle. For details on the
values to be changed, see the HP P9000 for Business Continuity Manager Reference Guide for
the description on the YKMONOPT and YKMONCG files.
CYCLETIME=cycle-time ~ <numeric characters> ((10 to 999999))
Used to change the CYCLETIME value specified in the YKMONOPT file. If the specified value is in
the range from 0 to 9, 10 is used.
WAITTIMEOUT=timeout-value ~ <numeric characters> ((0 to 999999))
Used to change the WAITTIMEOUT value specified in the YKMONOPT file.
MONITOR={START|STOP}
Used to change the monitoring status of a copy group specified in the YKMONCG file between
ACTIVE and INACTIVE.
• START
Used to change the monitoring status of the copy group to ACTIVE.
• STOP
Used to change the monitoring status of the copy group to INACTIVE.
CGID=copy-group-ID ~<GROUP string up to 38 characters>
Used to specify the copy group ID for which the monitoring status is changed to ACTIVE or
INACTIVE. If the specified copy group ID does not exist in the YKMONCG file, the MONITOR request
is canceled.
524 Automatic operation using BCM Monitor