HP P9000 Business Continuity Manager User Guide

Table 88 Overview of Business Continuity Manager Monitor parameter files
DescriptionParameter nameParameter typeFile name
Specifies the interval for monitoring (obtaining the
statuses of) copy groups
CYCLETIME
Cycle time
NoneYKMONOPT
Specifies the default timeout value for the CLI commands
specified in the YKMONCG file
WAITTIMEOUT
Default timeout value
Specifies the level of messages to be outputMSGLEVEL
Message level
Specifies the default value of the error actions specified
in the YKMONCG file
ONACTIONERROR
Default error action value
Specifies the following copy groups and their
environments
Copy group
parameter
YKMONCG
• CGID (Copy group ID)
• CGPREFIX (Prefix)
• Copy groups to monitor
• CGDAD (Host device
address domain ID)
• Copy groups for which actions will be executed
• Copy groups for which operator commands will be
issued
• CGROUTE (Route list ID)
Specifies whether to monitor the copy groupCGMONSTAT
Monitoring status
• ACTIVE: Monitors the copy group. If the copy group
changes to the specified target status, the designated
actions are executed.
• INACTIVE: Does not monitor the copy group.
Specify this parameter if you want to perform actions
for the copy group or display information about the
copy group by using the MODIFY REPORT
command without monitoring the status. You can
change the value to ACTIVE by using the MODIFY
SET command.
CGSTARTUPSTATUS
Startup status, startup
action
• Startup status: Specifies the status of the copy group
for when Business Continuity Manager Monitor starts
• Startup action: Specifies the action that is executed
when Business Continuity Manager Monitor starts
but the monitored copy group is not in the specified
startup status
Specifies the status of the copy group for which the
action is to be executed
STATUS
Target status
Action
parameter
ACTION
Action, error action
• Action: Specifies the action to perform when the
copy group is in the target status
• Error action: Specifies the action to perform when
the action that was executed results in an error
“Behavior of Business Continuity Manager Monitor” (page 516) describes how Business Continuity
Manager Monitor works when the Business Continuity Manager Monitor parameter files are
specified as shown in “Example of Business Continuity Manager Monitor parameter files” (page 515).
514 Automatic operation using BCM Monitor