HP P9000 Business Continuity Manager User Guide

Table 40 How to Prepare the Configuration Files at Each Site (continued)
How to PrepareContentsFile Type
On the Secondary SiteOn the Local SiteOn the Primary Site
Not requiredNot requiredDefine a path setPath set definition file
• An inter-control unit
logical path from
the primary site to
the local site
• An inter-disk
controller logical
path from the
primary site to the
remote site
Not requiredDefine a path setNot requiredAn inter-control unit
logical path from the
local site to the
primary site
Define a path setNot requiredNot requiredAn inter-disk controller
logical path from the
remote site to the
primary site
Not requiredNot requiredDefine a route listRoute list definition
file/Command
device definition file
• A route/command
device from the
primary site to the
local site
• A route/command
device from the
primary site to the
remote site
Not requiredDefine a route listNot requiredA route/command
device of Local ->
Primary -> Remote
Define a route listNot requiredNot requiredA route/command
device of Remote ->
Local -> Primary
Transfer from the
primary site
Transfer from the
primary site
Define a copy groupA Cnt-Ac S copy for
Mainframe group
Copy group
definition file
Define a copy groupA Cnt-Ac J copy for
Mainframe group
NOTE: If you define the route list, the route list definition file and the command device definition
file will be created at the same time.
Definition Procedure (3DC Multi-Target Configuration)
First, set the items that need to be set by using Remote Web Console from among the items listed
in Table 38 (page 150).
This section explains the definition of a 3DC Multi-Target configuration as shown in the ISPF panel.
The following explains the legend for the figures used for the operation procedures described in
this section:
152 Configuration Definitions