HP P9000 Business Continuity Manager User Guide

Table 39 Required Configuration Files (3DC Multi-Target Configuration) (continued)
RemarksDescriptionItem
Set this item before starting a copy
operation.
The route list defined for a 3DC
Multi-Target configuration must differ
Route list definition file
and command device
definition file from that for a 3DC Cascade
configuration for failover and failback.
• Route list for a 3DC Multi-Target
configuration
Route of Primary -> Local
Route of Primary -> Remote
• Route list for a 3DC Cascade
configuration
Route of Local -> Primary -> Remote
Route of Remote -> Primary -> Local
This item is not necessary if you use
Remote Web Console to set up logical
paths.
The following path sets are required for
logical paths.
Path set definition file
• An inter-control unit logical path is
required between the primary site and
the local site (for both directions).
• An inter-disk controller logical path is
required between the primary site and
the remote site (for both directions).
Preparing the Configuration Files (3DC Multi-Target Configuration)
Table 40 (page 151) shows how to prepare the configuration files at each site.
Table 40 How to Prepare the Configuration Files at Each Site
How to PrepareContentsFile Type
On the Secondary SiteOn the Local SiteOn the Primary Site
Transfer from the
primary site
Transfer from the
primary site
Perform a local scanThe primary site
configuration
Disk configuration
definition file
Transfer from the local
site
Perform a local scanTransfer from the local
site
The local site
configuration
Perform a local scanTransfer from the
remote site
Transfer from the
remote site
The remote site
configuration
Defining a 3DC Multi-Target configuration 151