HP P9000 Business Continuity Manager User Guide

Table 27 Storage system settings (NG Scan)
RemarksDescriptionItem
–Required to operate a Non Gen'ed
volume by using a command device.
Command device
—Inter-disk controller logical pathLogical path
Preparing the configuration files (NG Scan)
Table 28 (page 107) lists the configuration files required for executing an NG scan.
Table 28 Required configuration files (NG Scan)
RemarksDescriptionItem
—The disk configuration definition file
for a local scan and the disk
Disk configuration definition file
configuration definition file for an NG
scan are required.
A Non Gen'ed DAD ID cannot be
specified as a DAD ID in the route.
Required to operate a Non Gen'ed
volume by using a command device.
Route list definition file
NOTE: Required to establish, delete,
or acquire the inter-control unit logical
path when all volumes of the relevant
control unit are Non Gen'ed volumes.
This item is not necessary if you use
Remote Web Console to set up logical
paths.
A path set is required for inter-disk
controller logical paths.
Path set definition file
—Business Copy for Mainframe copy
group definition file
• DAD ID of a P-VOL: Specify the
DAD ID (Non Gen'ed DAD ID) for
an NG scan
• DAD ID of a S-VOL: Specify the
DAD ID for a local scan.
–Cnt Ac-J Z copy group definition file
• DAD ID of a P-VOL: Specify the
DAD ID for a remote scan.
However, when a local scan is
executed for a P-VOL, specify the
DAD ID for a local scan. (The Non
Gen'ed DAD ID cannot be
specified).
• DAD ID of a S-VOL: Specify the
DAD ID (Non Gen'ed DAD ID) for
an NG scan.
Performing a remote scan to acquire remote storage system information
Acquire remote storage system information by specifying a route list ID and performing a remote
scan. When the scan completes, assign a dummy device number.
Before performing a remote scan, make sure the following conditions are satisfied.
• A logical path (inter-control unit or inter-disk controller logical path) is established.
To confirm this, in the Path Set Status panel, which is displayed from the Manage Path Set
panel (from the Main Menu panel, choose 5 Manage Path Set), check whether a logical path
has been established
Acquiring volume information (preparations) 107