HP P9000 Business Continuity Manager Release Notes (T5253-96056, September 2011)

Table 19 Overview of CLI commands (continued)
RemarksDifferences from previous
version
4x4x4 configurationCLI command#
Not applicableNot applicableYKDELPTH6
NoneSupportedYKEWAIT7
Not applicableNot applicableYKFCSTAT8
NoneSupportedYKFREEZE9
NoneSupportedYKLOAD10
NoneSupportedYKMAKE11
NoneSupportedYKQRYDEV12
Not applicableNot applicableYKQRYPTH13
NoneSupportedYKQUERY14
If this situation occurs, issue
either the YKMAKE command
After performing Delta Resync,
if the Delta Resync copy pairs
between the Primary and
SupportedYKRECVER15
with the HOLD parameter to the
Remote sites are dissolved,
Delta Resync copy pairs
EXCTG information of Cnt Ac-J
between the Primary and
copy pairs between the Local
Remote sites, or the YKMAKE
and Remote sites is also deleted.
command with the
Therefore, issuing the YKQUERY
SELECT(COND) parameter to
command to such copy pairs
Cnt Ac-J copy pairs between the
causes the YKZ296E error
message to occur.
Local and Remote sites to
re-register them to EXCTG.
NoneSupportedYKRESYNC16
NoneSupportedYKRUN17
Not applicableNot applicableYKSCAN18
Not applicableNot applicableYKSLEEP19
NoneSupportedYKSTATS20
NoneSupportedYKSTORE21
NoneSupportedYKSUSPND22
NoneSupportedYKWATCH23
Setup procedure of 4x4x4 Multi-Target configuration with Delta Resync is equivalent to that of 4x4
configuration and 3DC Multi-Target configuration with Delta Resync except that there are some
restrictions on definition of Cnt Ac-S and 4x4 Cnt Ac-J.
Operation of 4x4x4 Multi-Target configuration with Delta Resync is same as that of 4x4 configuration
and 3DC Multi-Target configuration with Delta Resync.
Prerequisites 13