HP P9000 Business Continuity Manager Reference Guide (T5253-96058, September 2011)

because Business Continuity Manager cannot perform copy pair operations, if you change the
definitions of the items that require the YKMAKE or YKRESYNC command to make changes, the
changes will not be applied to the storage system settings.
Table 56 Contents of the Copy Group Attributes Panel
When effectiveCopy typeDescriptionItem
--
2
CADisplays the linkage option.Linkage Option
• HS: This is a CA copy group
with the HyperSwap attribute.
• NNE: This is something other than
the above.
For PPRC copy pairs in a 2DC
configuration with HyperSwap and
CAJ, specify HS. If this is a CA copy
group created by executing the
YKH2B command, HS is displayed.
If HS is displayed, Business
Continuity Manager can only be
used for monitoring, and cannot
perform any operations.
1
When the YKMAKE
command is executed.
3
BC
CA
Specify the C/T group ID (required
for TCA).
Specify a hexadecimal number
between 00 and 7F. This value
C/T ID
CAA
depends on the type of storage
system.
This option cannot be specified for
CA copy groups with the
HyperSwap attribute.
When the YKMAKE
command is executed.
3
CAJSpecify the journal group number
of the primary site as a C/T group
ID (required)
C/T ID (JNLG)
Specify a value between OO and
FF.
When the YKMAKE
command is executed.
3
CAJSpecify the journal group number
of the secondary site as a sub C/T
group ID (required)
sub C/T ID (JNLG)
Specify a value between OO and
FF.
NOTE: For configurations that use
delta resync, specify the same value
for both the UR copy pair and the
UR copy pair for delta resync.
When the YKMAKE
command is executed.
1
CAJSpecify the Mirror ID in the range
from 0 to 3 (required for CAJ).
4
MIRROR ID
Discover/Define Configuration Panel (Configuration File Definition) 79