HP P9000 Business Continuity Manager Reference Guide (T5253-96058, September 2011)

Inner Route Information Panel
If s is specified in AC in the Route Information panel, the Inner Route Information panel is displayed.
The Inner Route Information panel displays the detailed route information that begins with the
specified first DAD ID of the route.
Figure 37 (page 48) shows the Inner Route Information panel.
Figure 37 Inner Route Information Panel
Table 26 (page 48) describes the items in the Inner Route Information panel.
Table 26 Contents of the Inner Route Information Panel
DescriptionItem
Route list ID selected in the Route Config panelRoute List ID
PriorityPriority
Specify an action.AC
• s— Displays the Storage System Selection List panel that lists storage
system serial numbers in the DAD ID.
• d— Deletes the DAD ID. The first DAD ID of the route cannot be deleted.
DAD ID of the routeDevice Address Domain
List numberList
Serial number of the storage system to which the command device belongsS/NCmd Device
Device number of the command deviceDevn
A route is a connection between DADs. The route direction is from the smaller list number to the
larger list number as displayed in List. In the example shown on the Inner Route Information panel,
the route is from List numbers 1 to 2 (from DADP to DADR).
Figure 37 (page 48) indicates the DAD connection in ascending order of list numbers. S/N and
Devn show information on the storage system which is connected and the command device that
controls it. If these items are blank, this means that the information is not set. To create a route list,
you must set S/N and Devn for all the routes in the route list. To save a route list definition file, set
all of these command devices.
You cannot delete the first DAD ID of the route (the DAD ID indicated by 1 in the List). To delete
the first DAD ID of the route, delete the entire route by specifying d in the Route Information panel.
48 ISPF Panels