HP P9000 Business Continuity Manager Reference Guide (T5253-96058, September 2011)

STATS
Outputs operating information for the copy group. This can only be used for the TCA and CAJ
copy types.
RPO
Outputs consistency information for the copy group. This can only be used for the TCA and CAJ
copy types.
{CONS|ERROR|STATUS|INFO}
Specifies the message level of the messages that are to be output as report information. For details
on which messages are output for which message level settings, see “Values that Can Be Specified
for the Message Level and the Messages that Are Output for Each Level” (page 357).
WAITFOR(copy-group-ID,{DUPLEX|SUSPEND|SIMPLEX|SUSPVS|HOLD}[,timeout-value])
Executes the YKEWAIT command for the specified copy group and waits until the status changes
to the copy group status specified in this parameter. Note that if the specified timeout value is
reached before the specified status is obtained or if an invalid status results, the error action is
executed. For details on invalid statuses, see “Invalid Status for Each Value Specifiable in the
GOTO Parameter” (page 208).
{DUPLEX|SUSPEND|SIMPLEX|SUSPVS|HOLD}
Specifies the status of the copy group that is specified in the GOTO parameter of the YKEWAIT
command. After all copy pairs in the copy group have changed to the specified status, the
processing terminates normally. For details on this value, see the description of the GOTO parameter
in “YKEWAIT Command” (page 206).
timeout-value ~ <numeric characters> ((0 to 9999))
Specifies (in minutes) the timeout value that is specified in the TIMEOUT parameter in the YKEWAIT
command. If you omit this value, the value specified for the WAITTIMEOUT parameter in the
YKMONOPT file is used. For details on this value, see the description of the TIMEOUT parameter
in “YKEWAIT Command” (page 206).
RESYNC(copy-group-ID,command-wait-time[,command-parameter])
Executes the YKRESYNC command with the specified command parameter on the specified copy
group after the specified command wait time elapses.
command-wait-time ~ <numeric character>((0 to 9999))
Specifies in minutes the wait time before the YKRESYNC command is executed.
command-parameter ~ <up to 256 characters of command parameter string>
Specifies the YKRESYNC command parameters. The STEM and MSG parameters are ignored even
if they are specified. For details on the specifiable parameters, see the description of parameters
in “YKRESYNC Command” (page 236).
SUSPEND(copy-group-ID[,command-parameter])
Executes the YKSUSPND command with the specified command parameters on the specified copy
group.
command-parameter ~ <up to 256 characters of command parameter string>
Specifies the parameters of the YKSUSPND command. The STEM and MSG parameters are ignored
even if they are specified. For details on the specifiable parameters, see the description of
parameters in “YKSUSPND Command” (page 247).
In addition to the parameters that can be specified in the YKSUSPND command, the following
OFFSET parameter can also be specified:
OFFSET(mmmm:ss)
366 BCM Monitor Parameter Files