HP P9000 Business Continuity Manager Reference Guide (T5253-96058, September 2011)

Format
[STATUS=target-status,ACTION=action;[error-action;]]...
Information to be set
Specifies the target status, action, and error action for the copy group.
If the copy group is in the specified target status, the specified action will be executed. If the action
execution results in an error, the specified error action will be executed.
If you want to execute multiple actions, specify the parameters with the same target status in the
order you desire. An example is shown below:
STATUS=SUSPOP,ACTION=RESYNC(MYSI,0,’FORWARD’);
STATUS=SUSPOP,ACTION=WAITFOR(MYSI,DUPLEX);
STATUS=SUSPOP,ACTION=SUSPEND(MYSI,’FORWARD’);
STATUS=SUSPOP,ACTION=WAITFOR(MYSI,SUSPEND);
“Combinations of Target Statuses and Actions That Can Be Specified” (page 364) shows the
combinations of target statuses and actions that can be specified.
Table 165 Combinations of Target Statuses and Actions That Can Be Specified
Action
Target
status
PAUSESTOPPOINTSENDMSGMAKEDELETESUSPENDRESYNCWAITFORREPORTEXITNOP
YYYNNNNNYYYINVALID
YYYNYNNYYYYCONSLOST
YYYNYYYYYYYSUSPER
YYYNYYYYYYYNODELTA
YYYNYYYYYYYHOLDER
YYYNYYYYYYYSUSPCU
YYYYYNNYYYYSIMPLEX
YYYNYNNYYYYPENDING
YYYNNNNYYYYTRANS
YYYNYNNYYYYHOLDTRNS
YYYNYNNYYYYREVRSY
YYYNYYYYYYYSUSPVS
YYYNYYYYYYYSUSPOP
YYYNYYYYYYYHOLD
YYYNNNYYYYYSWAPPING
YYYNYYYYYYYDUPLEX
Legend
Y = This combination can be specified.
N = This combination cannot be specified.
Parameters
target-status
Specifies the status of the copy group on which the action is to be executed. For the specifiable
values, see “Combinations of Target Statuses and Actions That Can Be Specified” (page 364).
364 BCM Monitor Parameter Files