HP P9000 Business Continuity Manager Reference Guide (T5253-96058, September 2011)

The processing of this parameter is also for copy groups that has ACTIVE or INACTIVE specified
for the CGMONSTAT parameter.
The YKSUSPND command with the CANCEL parameter specified is executed if all of the following
conditions are satisfied:
• The copy group is a BC or TCA consistency group.
• DUPLEX is specified as the startup status.
• The status of the copy group is DUPLEX, or ADJUST is specified as the startup action.
• NOCANCEL is not specified.
If you do not want to execute the YKSUSPND command with the CANCEL parameter specified,
specify NOCANCEL.
If the copy group contains a copy pair in the TRANS or HOLDTRNS status, CGSTARTUPSTATUS
parameter processing is executed after the following processing is performed:
• When there is a copy pair in the TRANS status:
The YKEWAIT GOTO(SUSPEND) TIMEOUT(WAITTIMEOUT) command is executed.
• When there is a copy pair in the HOLDTRNS status:
The YKEWAIT GOTO(HOLD) TIMEOUT(WAITTIMEOUT) command is executed.
The value for WAITTIMEOUT is the value specified for the WAITTIMEOUT parameter in the
YKMONOPT file.
startup-status
Checks whether all the copy pair statuses in the copy group are the specified startup status. The
permitted values are SIMPLEX, DUPLEX, SUSPOP, or HOLD.
startup-action
Specifies the action to be executed if the copy group contains a copy pair that is not in the specified
startup status. The permitted values are as follows:
EXIT(return-code) ~ <numeric characters> ((0 to 4095))
Stops BCM Monitor with the specified return code. HP recommends that you specify a value other
than 0, 4, 8, or 12 because these numbers are already used as BCM Monitor return codes.
STOP
Changes the monitoring status of all the copy groups specified in the CGID parameter to INACTIVE.
ADJUST
Changes the copy pair status to the specified startup status.
Processing depends on the status of copy pairs in the copy group. For details on the processing
for changing the status to the startup status, see “Processing for Changing to the Startup Status”
(page 361).
NOCANCEL
Does not execute the YKSUSPND command with the CANCEL parameter specified. You can specify
this value only if you specified DUPLEX as the startup status.
Processing for Changing to the Startup Status
This section describes the processing of changing the copy group to the startup status when ADJUST
is specified for the CGSTARTUPSTATUS parameter. The copy group is sequentially searched for
a copy pair in the status indicated in the copy pair status column in “Processing for the Specified
YKMONCG File 361