HP P9000 Business Continuity Manager Reference Guide (T5253-96058, September 2011)

Installation Verification Summary panel
If any of the following conditions are met, the system assumes that the installation of Business
Continuity Manager did not complete and the Installation Verification Summary panel is displayed:
• No profile for referencing or operations has been specified for the RACF security setting.
• No user SVC has been registered.
• A user SVC version is enabled that cannot be used with the version of Business Continuity
Manager being installed.
For details on the Installation Verification Summary panel, see “Installation Verification Summary
Panel (Environment Settings Verification)” (page 23).
Set Defaults panel
If any of the following conditions are met, the Set Defaults panel for entering the prefix and Device
Address Domain ID is displayed:
• No values are set for Configuration File Prefix and Local Device Address Domain ID in the Set
Defaults panel.
• The prefix that was used the last time Business Continuity Manager was running is specified
for an instance of Business Continuity Manager agent with LOCK(PREFIX). After that, an attempt
is made to start the same instance of Business Continuity Manager as before while the instance
of Business Continuity Manager agent is still running.
If the configuration file is locked by the Business Continuity Manager agent as above, you
will be able to start an instance of Business Continuity Manager if, in the displayed Set Defaults
panel, you enter the prefix of an unlocked configuration file. If you press the F12=Cancel key
without entering a prefix, Business Continuity Manager will end.
For details on the Set Defaults panel, see “Set Defaults Panel (Prefix and DAD ID Settings)”
(page 26).
The Main Menu panel is shown in Figure 11 (page 22).
Figure 11 Main Menu Panel
Table 6 (page 23) lists the items in the Main Menu and their descriptions. Specify the number
corresponding to the operation to be performed.
22 ISPF Panels