HP P9000 Business Continuity Manager Reference Guide (T5253-96058, September 2011)

Table 100 Configuration Files That Must Be Loaded Before Command Execution (When
the Environment Does Not Contain a Non Gen'ed Volume) (continued)
Configuration file that must be loadedCommand name
Path set definition fileRoute list definition fileCopy group definition file
------YKSCAN
------YKSLEEP
--D
3
YYKSTATS
--D
2, 5
YYKSUSPND
------YKWATCH
------YKWTOMSG
1
You need to load the configuration file when operating a reverse-direction path.
2
When using the CA consistency preservation function (when operating a CA copy group with a consistency group ID
specified), you do not need to load the configuration file before executing the YKMAKE command. However, you need
to load the configuration file before executing other copy group operation commands.
3
You need to load the configuration file when acquiring information about an S-VOL that is not recognized by the host.
4
You need to load the configuration file when you operate a CG container with EXCTG ID specified.
5
You need to load the configuration file when the copy type is CA, CAA, or CAJ and when you specify the REVERSE
parameter.
Legend:
Y: You need to load the configuration file.
D: Whether you need to load the configuration file depends on the situation.
--: You do not need to load the configuration file.
Table 101 Configuration Files That Must Be Loaded Before Command Execution (When the
Environment Contains a Non Gen'ed Volume)
Configuration file that must be loadedCommand name
Path set definition fileRoute list definition fileCopy group definition file
--Y--YKBLDCMD
YD
1
--YKBLDPTH
------YKCONMSG
--Y--YKDELCMD
--D
2
YYKDELETE
YD
1
--YKDELPTH
------YKERCODE
--D
2
YYKEWAIT
------YKEXPORT
------YKFCSTAT
----YYKFREEZE
------YKH2B
------YKIMPORT
------YKINSCHK
Configuration Files That Must Be Loaded Before Command Execution 187