HP P9000 Business Continuity Manager Reference Guide (T5253-96058, September 2011)

Table 85 Contents of the Suspension Options Panel (continued)
DescriptionItem
Format of the ATTIME suspend time is as follows:
• YYYY: Specify the year (1970 to 2042)
• MM: Specify the month (01 to 12)
• DD: Specify the date (01 to 31)
• HH: Specify the time (00 to 23)
• MM: Specify the minute (00 to 59)
• SS: Specify the second (00 to 59)
• mmmm: Specify the offset value to be added to the ATTIME suspend
time in minute (0000 to 1439)
• ss: Specify the offset value to be added to the ATTIME suspend
time in second (00 to 59)
Specify the TIMEOUT parameter of the YKSUSPND command in
minutes (from 0 to 9999).
Timeout Minutes MMMM
The specified value is used as the timeout value when the CAJ ATTIME
suspend function is used.
Specify the ATTIME parameter (the time used as the ATTIME suspend
time) of the YKSUSPND command by using the number.
LOCAL or GMT
LOCAL: Uses the local time as the ATTIME suspend time.
GMT: Uses Greenwich Mean Time as the ATTIME suspend time.
Specify the value of the YKSUSPND command ATOPT parameter that
corresponds to the type of ATTIME suspend function you want to use.
Preset Mode
• NORMAL: Uses the NORMAL ATTIME suspend function. For details
on whether the secondary volumes can be accessed or updated
while a BC copy group for which NORMAL is specified is being
transitioned to suspend mode, see the Business Copy for Mainframe
Systems UserGuide: HP XP24000 Disk Array, HP XP20000 Disk
Array.
• CAJ(Steady): Uses the CAJ ATTIME suspend function. The copy
group runs in STEADY mode during its transition to suspend mode.
• CAJ(Quick): Uses the CAJ ATTIME suspend function. The copy
group runs in QUICK mode during its transition to suspend mode.
When a BC copy group for which the ATTIME function is not enabled
is being used, use Suspend Option to specify the mode that is active
during the transition to suspend mode.
Specify the GENID parameter of the YKSUSPND command (from 00
to FF).
Generation ID
The specified value is used as the number for identifying backup
generations.
Specify the VOLUNIT parameter of the YKSUSPND command:VolUnit
• Y: Performs operations on a volume basis, even for an environment
that supports operations on a group basis during specification. An
error will occur if you perform a suspend operation that reverses
the copy direction for TCA and CAJ copy groups after
resynchronization.
• N: Performs operations on a group basis if this is supported by the
environment.
If the Preset is specified for the Suspend Option, VolUnit will be
disregarded even when set to Y.
Manage Copy Groups Panel (Copy Group Operation) 161