HP P9000 Business Continuity Manager Reference Guide (T5253-96058, September 2011)

Table 2 Commands that Can Be Used on the Command Line (continued)
Command NamePanel Name
ERRCODESCANPAIRSORTSELECTLOCATE
Y——Y—Pair Selection List (Secondary)
Y—Y
1
——Path Set Detail
Y—Y
1
——Path Set Status
Y—Y
1
——Path Set Status of Copy Group Pair
—————Setting Information
Y—Y—Y
Hitachi TrueCopy™ Asynchronous
for Mainframe Copy Group
Performance Statistics
Y—Y—YContinuous Access Journal for
Mainframe Copy Group
Performance Statistics
Y————Others
1
This command can be used, but you cannot specify field names.
2
Pressing the F5=ErrCode key will also execute the command.
Legend:
Y: Can be used
—: Cannot be used
ISPF Settings
Setting the Position of the Command Line
You can specify whether to position the command line at the top or at the bottom of each panel.
To set the position of the command line:
1. Start Business Continuity Manager. Type SETTINGS on the command line, and then press
the Enter key.
The ISPF Settings panel appears.
2. To display the command line at the top of panels, clear the Command line at bottom check
box. To display the command line at the bottom of panels, select the Command line at bottom
check box.
Setting the Number of PF Keys that are Displayed
You can set the number of PF keys that are displayed. This setting is saved in the profile even after
Business Continuity Manager is stopped
To set the number of PF keys that are displayed:
1. Start Business Continuity Manager. Type PFSHOW TAILOR on the command line, and then
press the Enter key.
The ISPF Settings panel appears.
2. Set a value in Number of keys.
NOTE: If the value set is reached with the keys between F1 and F12, the F17=DispConf key
is not displayed.
14 ISPF Panels