P9000Watch and P9000Sketch Reference guide for HP StorageWorks P9000 Performance Advisor v5.4 (T1789-96332, April 2012)

The Sync/Async Metrics provides configuration information for each P-VOL and S-VOL which includes
data displayed in the following table:
DescriptionScreen field
Selection Number.Num
S against a P-VOL or S-VOL record indicates that the particular record is selected.Sel
Serial number of the XP or P9000 disk array.Pri Ser#
LDEV configured as P-VOL or S-VOL on the selected disk array (primary data center).
Displays the LDEV number in cu:ldev format.
Ldev
Type of the LDEV, can be P-VOL or S-VOL.Type
CLPR that manages cache for the P-VOL or S-VOL.CLPR
RAID group to which the P-VOL or S-VOL belongs.Rg
RAID classification for the RAID group.RAID
RAID type for the RAID group.Type
Size of the LDEV in MB.Ld[MB]
Current replication link status of the P-VOL or S-VOL on the selected XP or P9000 disk
array. The replication link status shown is corresponding to only the selected XP or P9000
disk array and can be one of the following:
• SMPL: Unpaired volume
• PAIR: Paired duplicate volume
• COPY: In paired state but copying to secondary volume not complete
• PSUS: In paired state but updating the secondary volume data is suspended
• PSUE: PSUS state due to internal error
• PFUS: PSUS state due to Side File Full
State
Mirror Unit Number of the paired volume.MUN
Consistency Group ID: A Group ID which guarantees consistency in the sequence of
asynchronous data transfers for a remote copy volume group.
CTG
Journal ID of the journal group associated with the P-VOL or S-VOL.JID
Fence level of target device (Pair volume). ASYNC for asynchronous communications
and DATA, STATE, or NEVER for synchronous communications.
Fence
Number of active paths for a P-VOL, the continuous access links (P-VOL to S-VOL). When
continuous access is configured as Sync or Async and the selected volume type is SVOL,
then you might encounter the status of the number of paths as NA - Not Applicable.
Paths
Secondary data center disk array serial number on which the S-VOL resides.Sec Ser#
LDEV configured as S-VOL on the secondary data center disk array. Displays the LDEV
number in cu:ldev format.
Ldev
Working with P9000Watch menus and commands26