P9000Watch and P9000Sketch Reference guide for HP StorageWorks P9000 Performance Advisor v5.2 (T1789-96319, May 2011)

To view the P9000Watch in CLI mode.—c
To specify the XP or P9000 disk array serial number.—s
To specify the host group which has to be monitored. You can provide multiple entries for host
groups.
NOTE:
There should be no space in between the comma separating the host groups.
For example, –hg Node7,Node8
—hg
This is an optional parameter. It is used to specify the .csv filename. If this option is not specified,
the archive file (.csv file) will not be created.
—f
This is an optional parameter. It is used to specify the frequency of archiving data in the .csv
file. If this option is not specified then the previously specified value shall be used. For more
information, see Table 13.
—a
This is a mandatory option and is used to specify the number of hours for which P9000Watch
must be active.
—i
./xpwatch –c –s <array -serial number> -l <all|ldev-list> -p <all|port-list> -r <all|rg-list> [-f <filename>]
[-a <frequency for archiving data>] -i <number of hours for execution>
To view the P9000Watch in CLI mode.—c
To specify the XP or P9000 disk array serial number.—s
To view the list of LDEVs that must be given in a comma separated format. If 'all' is specified in
the parameter, it will consider all the LDEVs for that particular disk array.
NOTE:
There should be no space in between the comma separating the LDEVs.
For example, –l 02:00,02:01
—l
To view the list of ports that must be given in a comma separated format. If “all” is specified in
the parameter, it will consider all the ports for that particular disk array.
NOTE:
There should be no space in between the comma separating the ports.
For example, –p 1a,2a
—p
To view the list of RAID groups that must be given in a comma separated format. If “all” is specified
in the parameter, it will consider all the RAID groups for that particular disk array.
NOTE:
There should be no space in between the comma separating the RAID groups.
For example, –r 01–10,10–01
—r
This is an optional parameter. It is used to specify the .csv filename. If this option is not specified,
the archive file (.csv file) will not be created.
—f
This is an optional parameter. It is used to specify the frequency of archiving data in the .csv
file. If this option is not specified then the previously specified value shall be used. For more in-
formation, see Table 13.
—a
Working with P9000Watch menus and commands22