OpenVMS Support For HP P9000 Performance Advisor Whitepaper
Table Of Contents
- Introduction
- Intended Audience
- Verifying host connectivity to a command device
- Prerequisite
- Executing the OpenVMS Integrity Server host agent installer
- Confirming the P9000 Performance Advisor OpenVMS Integrity Server host agent services
- Verifying if the host agents appear in P9000 Performance Advisor
- Enable autostart for P9000PA services after every reboot of system
- Manual restart for P9000PA services
- Manual stop of P9000PA Services
- Glossary
- For more information
_$1$DGA86: --- --- --- CL4A 00:56 OPEN-V-CM 53046
_$1$DGA118: --- --- --- CL8D 00:76 OPEN-V-CM 53040
_$1$DGA119: --- --- --- CL8D 00:77 OPEN-V-CM 53040
_$1$DGA120: --- --- --- CL8D 00:78 OPEN-V-CM 53040
_$1$DGA121: --- --- --- CL8D 00:79 OPEN-V 53040
_$1$DGA123: --- --- --- CL8D 00:7b OPEN-V-CM 53040
_$1$DGA130: --- --- --- CL4A 00:82 OPEN-V 53046
_$1$DGA134: --- --- --- CL4A 00:86 OPEN-V-CM 53046
_$1$DGA274: --- --- --- CL8D 01:12 OPEN-V 53036
_$1$DGA275: --- --- --- CL8D 01:13 OPEN-V 53036
_$1$DGA385: --- --- --- CL8D 01:81 OPEN-V-CM 53036
_$1$DGA395: --- --- --- CL8D 01:8b OPEN-V 53036
_$1$DGA399: --- --- --- CL8D 01:8f OPEN-V 53036
_$1$DGA441: --- --- --- CL8D 01:b9 OPEN-0V 53036
_$1$DGA442: --- --- --- CL8D 01:ba OPEN-0V 53036
_$1$DGA513: --- --- --- CL8D 02:01 OPEN-V 53036
Prerequisite
Download the OVMS Host agent (XPPA_HA_OVMS_IA64.tar) tar file from the P9000 Performance Advisor
support page, untar it, and then transfer the host agent (HP-I64VMS-P9000HAV0504--1.PCSI) file to host.
Executing the OpenVMS Integrity Server host agent installer
To run the OpenVMS Integrity Server host agent installer:
1. Log into the OpenVMS host as a "system" user.
2. Navigate to the tmp directory or to the folder where you copied the HP-I64VMS-P9000HAV0504--1.PCSI
file.
3. At the prompt, enter product install p9000ha to begin the installation. The installation script displays a
series of prompts. Respond to these prompts as appropriate for your environment.
4. Click Y to continue.
5. Enter a valid IPv4 address of the management station. Ensure that both the P9000 Performance Advisor
and host agent uses the same protocol, IPv4, to communicate. Also, configure the HTTP port that the host
agent must use to communicate with P9000 Performance Advisor.
6. Enter the port number that the host agent must use to communicate with the management station.
7. Press Enter to confirm the details and begin the installation. The installation wizard installs the P9000
Performance Advisor OVMS host agent in the following location:
SYS$COMMON:[HEWLETTPACKARD.P9000HOSTSW]
The P9000 Performance Advisor OpenVMS Integrity Server host agent is installed according to the
selected settings. After the installation is complete, the host agent services start.