HP XP P9000 Performance Advisor v6.0 Software Troubleshooting and FAQs Guide

Table 14 Configuring the password required to access HP XP P9000 Performance Advisor
You can change the user and administrator passwords
through the Security screen of HP XP P9000 Performance
Advisor.
NOTE: If you are the administrator, you can change other
user(s) and administrator(s) passwords on the Security
screen of HP XP P9000 Performance Advisor, only if HP
XP P9000 Performance Advisor is enabled for Native
authentication. You cannot change the passwords for
domain and system authenticated user accounts.
Discussion
Table 15 Disabling recover alarm notification
...%HPSS_HOME%/pa/properties/serverparameters.propertiesFile
You can disable recover alarm notification through the
Alarm Configuration page of HP XP P9000 Performance
Advisor.
NOTE: You can also configure the email (SMTP) courier
settings for reports from the HP XP P9000 Performance
Advisor GUI. For more information, see the HP XP P9000
Performance Advisor Software User Guide.
Discussion
Table 16 Configuring the host agent: Logger.DebugLevel
On Windows platforms:
C:\Program Files\Hewlett-Packard\xppa\
hostagent\config\paxp_service.properties
File
If installed in a different location, the path is as follows:
<Installation drive>:\xppa\hostagent\
config\paxp_service.properties.
On UNIX platforms:
/opt/xppa/hostagent/config/
paxp_service.properties
This parameter allows you to specify the logging level for
the host agent log files. The minimum and default level is
1, and the maximum level is 10.
Discussion
Table 17 Configuring the host agent: Logger.LogFileSize
On Windows platforms:
C:\Program Files\Hewlett-Packard\xppa\
hostagent\config\paxp_service.properties
File
If installed in a different location, the path is as follows:
<Installation drive>:\xppa\hostagent\
config\paxp_service.properties.
On UNIX platforms:
/opt/xppa/hostagent/config/
paxp_service.properties
This parameter allows you to specify the size of log files
that you want to retain on the host. The default file size
Discussion
value is 100MB. However, you can also provide the
equivalent value in terms of MB and GB. The default value
will be considered for any specification that is beyond the
acceptable value.
Configuration FAQs 81