HP XP P9000 Performance Advisor v6.0 Software Troubleshooting and FAQs Guide

Table 11 Formatting and content of SNMP trap messages sent by HP XP P9000 Performance Advisor
(continued)
.1.3.6.1.4.1.11.2.27.5.1.6 (Metric Value)
.1.3.6.1.4.1.11.2.27.5.1.7 (DKC Serial Number)
.1.3.6.1.4.1.11.2.27.5.1.8 (DKC Type)
.1.3.6.1.4.1.11.2.27.5.1.9 (Level of the Detection)
.1.3.6.1.4.1.11.2.27.5.1.10 (Actual Value)
.1.3.6.1.4.1.11.2.27.5.1.11 (Threshold)
.1.3.6.1.4.1.11.2.27.5.1.12 (Time Stamp)
Table 12 Configuring the host agent: ManagementStation.Hostname
On Windows platforms:
C:\Program Files\Hewlett-Packard\xppa\
hostagent\config\paxp_service.properties
File
If installed in a different location, the path is as follows:
<Installation drive>:\xppa\hostagent\config\
paxp_service.properties.
On UNIX platforms:
/opt/xppa/hostagent/config/
paxp_service.properties
Common for both Windows and UNIX platforms:
C:\Program Files\Hewlett- Packard\xppa\
hostagent\config\xpmgmtstationaddress.prp.
These parameters are read when the host agent is started. The
host normally executes as a service under Microsoft Windows
or as a daemon under UNIX.
When Read
IP address or fully-qualified network name of management station.
NOTE: This host agent is configured automatically during host
agent installation. Configure this host agent manually only when
you want to change the management station after installing the
host agent.
Discussion
The xpmgmtstationaddress.prp file needs to be updated
with the IP address of the management station, if you want to
use a different management station after installing the host agent.
Table 13 Configuring the host agent: ManagementStation.PollIntervalMilliSeconds
On Windows platforms:
C:\Program Files\Hewlett-Packard\xppa\
hostagent\config\paxp_service.properties
File
If installed in a different location, the path is as follows:
<Installation drive>:\xppa\hostagent\
config\paxp_service.properties.
On UNIX platforms:
/opt/xppa/hostagent/config/
paxp_service.properties
This parameter is read and specified at run time.When Read
The frequency at which the Host station polls the
Management station for updates. The default for the polling
cycle is 60000 (60 seconds).
Discussion
80 Frequently Asked Questions