HP XP P9000 Performance Advisor v6.0 Software Troubleshooting and FAQs Guide

3 Error messages
This section describes the error messages for HP XP P9000 Performance Advisor. The error messages
are presented in the following format:
• Error Title: Provides a brief description of the error
• Error Description: Provides the cause of the error
• Solution or Workaround: Provides the solution for resolving the error, or a workaround
Installation error messages
Table 1 (page 41) describes the error messages that you might see when installing HP XP P9000
Performance Advisor.
Table 1 Installation error messages
Solution or WorkaroundError DescriptionError Title
For steps on how to configure a static IP
address or Loopback Adapter, refer to the HP
The installation wizard has detected that your
management station does not have a static IP
Static IP address or
Loopback Adapter is
XP P9000 Performance Advisor install guide
available on Disk 1.
address or Loopback Adapter configured. They
should be configured for the installation wizard
to proceed.
not configured on this
management station.
Upgrade the processor speed to 800 MHz or
install HP XP P9000 Performance Advisor on
The installation wizard has detected that your
management station's processor speed is less
The processor speed
is less than 800 MHz
a management station that already has the
processor speed set to 800 MHz or greater.
than 800 MHz. It should at least be 800 MHz
for the installation wizard to proceed.
on this management
station.
Release the required free disk space on your
management station. The installation wizard
The installation wizard has detected that
sufficient disk space is not available on the
Insufficient disk space
in <Install_drive>.
will exit now. After you make the required diskdisk drive, where you are trying to install HP
space available, double clickXP P9000 Performance Advisor. There must
PA_Server.exe to resume the installation of
HP XP P9000 Performance Advisor.
be at least 8 GB of free space available for
the installation wizard to proceed.
Remove Command View XP for the installation
wizard to proceed. For more information, refer
The installation wizard has detected that an
instance of Command View XP is already
Command View XP is
already installed on
to the Command View XP install guide. Theinstalled on this management station.this management
station installation wizard will exit now. After youCommand View XP must be removed before
remove Command View XP, double clickHP XP P9000 Performance Advisor can be
installed. PA_Server.exe to resume the installation of
HP XP P9000 Performance Advisor.
Upgrade the physical memory on your
management station to 1 GB RAM or higher.
The installation wizard has detected that
sufficient physical memory is not available on
Insufficient physical
memory on this
management station. The installation wizard will exit now. After youthis management station. There must be at least
upgrade the physical memory, double click1 GB of physical memory available for the
installation wizard to proceed. PA_Server.exe to resume the installation of
HP XP P9000 Performance Advisor.
Create at least 1 GB of free disk space in your
management station’s <Install_drive>\
The installation wizard has detected that
sufficient free disk space is not available in the
<Install_drive>\TEMP on this
management station.
Insufficient free disk
space in the
<Install_drive>\TEMP
folder on this
management station.
TEMP folder (required only if you are selecting
a Complete installation for HP XP P9000
Performance Advisor).
Create the domain administrator group on your
management station if you want to implement
The installation wizard has detected that the
administrator group does not exist on your
The entered admin
group does not exist
Domain authentication method. For moremanagement station. This group must be
created for the installation wizard to proceed.
in the domain
provided. information on Domain authentication method,
refer to the HP XP P9000 Performance Advisor
install guide available on Disk 1. The
installation wizard will exit now. After you
create the groups, double click
Installation error messages 41