HP XP P9000 Performance Advisor v5.5 Software Troubleshooting and FAQs Guide (T1789-96344, February 2013)

Table 15 Configuring the host agent: Logger.DebugLevel (continued)
/opt/xppa/hostagent/config/
paxp_service.properties
This parameter allows you to specify the logging level for
the host agent log files. The minimum and default level is
1, and the maximum level is 10.
Discussion
Table 16 Configuring the host agent: Logger.LogFileSize
On Windows platforms:
C:\Program Files\Hewlett-Packard\xppa\
hostagent\config\paxp_service.properties
File
If installed in a different location, the path is as follows:
<Installation drive>:\xppa\hostagent\
config\paxp_service.properties.
On UNIX platforms:
/opt/xppa/hostagent/config/
paxp_service.properties
This parameter allows you to specify the size of log files
that you want to retain on the host. The default file size
Discussion
value is 100MB. However, you can also provide the
equivalent value in terms of MB and GB. The default value
will be considered for any specification that is beyond the
acceptable value.
Table 17 Configuring the host agent: Logger. LogFileSize
On Windows platforms:
C:\Program Files\Hewlett-Packard\xppa\
hostagent\config\paxp_service.properties
File
If installed in a different location, the path is as follows:
<Installation drive>:\xppa\hostagent\
config\paxp_service.properties.
On UNIX platforms:
/opt/xppa/hostagent/config/
paxp_service.properties
This parameter also allows you to specify the number of
logs that you want to retain on the host. By default, you
can retain a minimum of three revisions of the log file.
Discussion
Table 18 Configuring the host agent: Protocol
On Windows platforms:
C:\Program Files\Hewlett-Packard\xppa\
hostagent\config\paxp_service.properties
File
If installed in a different location, the path is as follows:
<Installation drive>:\xppa\hostagent\
config\paxp_service.properties.
On UNIX platforms:
/opt/xppa/hostagent/config/
paxp_service.properties
This parameter indicates the protocol that must be used,
either http or https. The protocol needs to be changed to
Discussion
https when using the Secure Socket Layer (SSL) for
communication.
Configuration FAQs 79