HP XP P9000 Performance Advisor v5.5 Software Troubleshooting and FAQs Guide (T1789-96344, February 2013)

Table 11 Configuring the host agent: ManagementStation.Hostname (continued)
The xpmgmtstationaddress.prp file needs to be updated
with the IP address of the management station, if you want to
use a different management station after installing the host agent.
Table 12 Configuring the host agent: ManagementStation.PollIntervalMilliSeconds
On Windows platforms:
C:\Program Files\Hewlett-Packard\xppa\
hostagent\config\paxp_service.properties
File
If installed in a different location, the path is as follows:
<Installation drive>:\xppa\hostagent\
config\paxp_service.properties.
On UNIX platforms:
/opt/xppa/hostagent/config/
paxp_service.properties
This parameter is read and specified at run time.When Read
The frequency at which the Host station polls the
Management station for updates. The default for the polling
cycle is 60000 (60 seconds).
Discussion
Table 13 Configuring the password required to access HP XP P9000 Performance Advisor
You can change the user and administrator passwords
through the Security screen of HP XP P9000 Performance
Advisor.
NOTE: If you are the administrator, you can change other
user(s) and administrator(s) passwords on the Security
screen of HP XP P9000 Performance Advisor, only if HP
XP P9000 Performance Advisor is enabled for Native
authentication. You cannot change the passwords for
domain and system authenticated user accounts.
Discussion
Table 14 Disabling recover alarm notification
...%HPSS_HOME%/pa/properties/serverparameters.propertiesFile
You can disable recover alarm notification through the
Alarm Configuration page of HP XP P9000 Performance
Advisor.
NOTE: You can also configure the email (SMTP) courier
settings for reports from the HP XP P9000 Performance
Advisor GUI. For more information, see the HP XP P9000
Performance Advisor Software User Guide.
Discussion
Table 15 Configuring the host agent: Logger.DebugLevel
On Windows platforms:
C:\Program Files\Hewlett-Packard\xppa\
hostagent\config\paxp_service.properties
File
If installed in a different location, the path is as follows:
<Installation drive>:\xppa\hostagent\
config\paxp_service.properties.
On UNIX platforms:
78 Frequently Asked Questions