HP XP P9000 Performance Advisor v5.5 Software Troubleshooting and FAQs Guide (T1789-96344, February 2013)

ManualsBrandsHP ManualsSoftwareHP XP P9000 Performance Advisor Software

Table 10 Formatting and content of SNMP trap messages sent by HP XP P9000 Performance Advisor

...%HPSS_HOME%\pa\properties\serverparameters.propertiesFile

The message is of type SNMPv1. It has the following

formant and content:

PDU version -- 0 (indicates type SNMPv1)

Discussion

Community -- public

Message type -- 0xa4 (indicates a trap message)

Enterprise -- The vendor identification (OID).

Agent-Address -- The IP address of the management station

where the trap is generated.

Generic Trap Type -- 6 (enterprise-specific)

Timestamp -- 0 (not used)

Variable bindings -- This field consists of a sequence of

(oid/name=value) pairs. The content is the same as the

message that is sent by e-mail.

Following is the list of OIDs:

.1.3.6.1.4.1.11.2.27.5.1.1 (Server Name)

.1.3.6.1.4.1.11.2.27.5.1.2 (Sequence Number)

.1.3.6.1.4.1.11.2.27.5.1.3 (Source Application)

.1.3.6.1.4.1.11.2.27.5.1.4 (Alarm Type)

.1.3.6.1.4.1.11.2.27.5.1.5 (Minor Type)

.1.3.6.1.4.1.11.2.27.5.1.6 (Metric Value)

.1.3.6.1.4.1.11.2.27.5.1.7 (DKC Serial Number)

.1.3.6.1.4.1.11.2.27.5.1.8 (DKC Type)

.1.3.6.1.4.1.11.2.27.5.1.9 (Level of the Detection)

.1.3.6.1.4.1.11.2.27.5.1.10 (Actual Value)

.1.3.6.1.4.1.11.2.27.5.1.11 (Threshold)

.1.3.6.1.4.1.11.2.27.5.1.12 (Time Stamp)

Table 11 Configuring the host agent: ManagementStation.Hostname

On Windows platforms:

C:\Program Files\Hewlett-Packard\xppa\

hostagent\config\paxp_service.properties

File

If installed in a different location, the path is as follows:

<Installation drive>:\xppa\hostagent\config\

paxp_service.properties.

On UNIX platforms:

/opt/xppa/hostagent/config/

paxp_service.properties

Common for both Windows and UNIX platforms:

C:\Program Files\Hewlett- Packard\xppa\

hostagent\config\xpmgmtstationaddress.prp.

These parameters are read when the host agent is started. The

host normally executes as a service under Microsoft Windows

or as a daemon under UNIX.

When Read

IP address or fully-qualified network name of management station.

NOTE: This host agent is configured automatically during host

agent installation. Configure this host agent manually only when

you want to change the management station after installing the

host agent.

Discussion

Configuration FAQs 77