HP StorageWorks P9000 Performance Advisor Software v5.4 Install Guide (T1789-96330, April 2012)

Figure 11 P9000 Performance Advisor Windows host agent log file
.
Based on whether you have performed an installation or upgrade, do one of the following:
• Return to the installation checklist to complete the remaining checklist items. For more information,
see Table 2 on page 16.
• Return to the upgrade checklist to complete the remaining checklist items. For more information,
see Table 12 on page 110.
If you want to install the P9000 Performance Advisor UNIX host agents, see “Installing the P9000
Performance Advisor UNIX host agents” on page 80.
Confirming the P9000 Performance Advisor Windows host agent services
To confirm whether the P9000 Performance Advisor Windows host agent services have started:
1. Select Start > Run, type services.msc, and press the Enter key.
The Services dialog box appears.
2. If the P9000 Performance Advisor Windows host agent has been installed, the status of the
following services are in the Started mode:
• HP StorageWorks P9000 Performance Advisor Hostagent
• HP StorageWorks P9000 Performance Advisor Realtime Server
Figure 12 Services dialog box - Confirming Windows host agent major services
.
The HP P9000 Performance Advisor Realtime Server appears, only if you have
selected the real-time component while installing the host agent.
If the Windows host agent service has not started automatically, manually start the host agent service.
For more information, see Appendix B.
Installing the P9000 Performance Advisor UNIX host agents
NOTE:
This section is also applicable for the upgrade process.
This section describes installing the P9000 Performance Advisor UNIX host agents. The installation
process is described in the following topics:
• “Executing the UNIX host agent installer” on page 81
• “Enabling the UNIX host agent to use IPv6” on page 81
• “Completing the UNIX host agent installation and next steps” on page 82
Installing the P9000 Performance Advisor host agents80