HP StorageWorks P9000 Performance Advisor Software v5.4 Install Guide (T1789-96330, April 2012)

Microsoft Loopback AdapterDescription
02-00-4C-4F-4F-50Physical Address
NoDHCP Enabled
169.254.25.129IP Address
255.255.0.0Subnet Mask
For more information on configuring Loopback Adapters, see Appendix A on page 133.
Static IP address
To assign a static IP address, do the following:
1. Right-click My Network Places and select Properties.
2. In the Network Connections window, right-click the network that you are using and select Prop-
erties from the pop-up list.
3. In the Local Area Connection Properties window, select Internet Protocol (TCP/IP) from the This
connection uses the following items list, and click Properties.
4. In the Internet Protocol (TCP/IP) Properties window, select the Use the following IP Address option
and provide the IP address details.
Similarly, select the Use the following DNS server addresses option and provide the relevant details.
5. Click OK on the Internet Protocol (TCP/IP) Properties window and the Local Area Connection
Properties window.
Assigning ports for P9000 Performance Advisor on the management station
NOTE:
This section is applicable only if you want to install P9000 Performance Advisor on the management
station. This information is not applicable if you want to perform an upgrade procedure.
Port 80 on your management station is the default port that the HP StorageWorks P9000 Performance
Advisor Tomcat service in P9000 Performance Advisor uses for all its communications. However, you
can configure P9000 Performance Advisor to use a different port by specifying that port number
during the installation. The same port number should be specified during the Windows and UNIX
host agents installation, so that the host agents can communicate with P9000 Performance Advisor.
Understanding the P9000 Performance Advisor installation prerequisites30