HP StorageWorks P9000 Performance Advisor Software v5.4 Command-line User Interface Reference Guide (T1789-96329, April 2012)

Displays the actual number of paths.AP
Displays the usage rate of the journal pool in percentage format.U(%)
Displays the sequence number for the journal group ID, called the Q-marker.Q-Marker
Displays the number of remaining Q-Markers within each journal volume.Q-CNT
Displays the number of volumes configured for the journal group.Num
Displays the ID of the volume configured for the journal group.LDEV#
Displays the average read response time of the volume configured for the journal group.Avg Read
Displays the maximum read response time of the volume configured for the journal group.Max Read
N/AAvg Write
N/AMax Write
NOTE:
Average and Maximum write metrics are not supported for the continuous access journal pool LDEVs.
Switches
Required: Specify the array serial number.—dkc <serial #>
Specify the journal ID.
–jid <journal pool
id>
The journal LDEV's read and write response time.–resp
Specify the start time in the format mm.dd.yyyy hh:mm:ss.
–st <mm.dd.yyyy
hh:mm:ss>
Specify the end time in the format mm.dd.yyyy hh:mm:ss.
–et <mm.dd.yyyy
hh:mm:ss>
Specify the address of a management station in the format <http://path.to.man-
agementstation:<port>> or <https://path.to.managementstation>.
–ms <URL>
Specify a user name and password pair in the format user name:password.
–auth <user:pass-
wd>
Can be used in place of –auth.
NOTE:
The password file must be created using the encrypt command only.
–pf <password
file>
Specify the delimiter for delimited display.–d<delim>
Display column headers with delimited data.–L
Displays data in a human readable format.–hr
Prints this usage statement.–?
CLUI commands58