HP XP7 Tiered Storage Manager CLI Reference Guide (TK985-96002, May 2014)

Specifiable values or charactersOperatorsProperty name
For GetStorageArray
(subtarget=LogicalUnit) in Device
Manager CLI, specify the value
displayed for the raidType attribute
of the LogicalUnit object.
Specify this in the format of RAIDx, or
RAIDx(yD+zP).
RAIDx: RAID level
yD: Number of data drives
zP: Number of parity drives
Specify no more than 75 bytes.
=, <>RAIDLevel
For GetStorageArray in Device
Manager CLI, specify the value
displayed for the name attribute of the
StorageArray object.
Specify no more than 384 bytes.
=, <>SubsystemName
For GetStorageArray in Device
Manager CLI, specify the value
displayed for the vendor attribute of
the VolumeConnection object.
Specify no more than 150 bytes.
=, <>SubsystemVendor
Specify a positive integer, or a positive
integer with a unit. (For example, 256,
500KB, or 10MB.)
• Specify an integer from 0 to
9,223,372,036,854,775,807KB
• The units you can specify are KB,
MB, GB, and TB. KB is the default
unit.
#1
=, <>, >, >=, <, <=TotalFreeCapacity
#1
When possible, capacity values in the output information of CLI commands are expressed in a
higher-order unit than the unit specified by the user. For example, the value 10,240 KB is displayed
as 10MB.
#2
For the drive capacity, a value in KB is obtained from Device Manager. However, in Tiered
Storage Manager, the gigabyte-conversion of those values is used. This conversion involves dividing
the drive capacity by 1,048,576 (1,024 x 1,024) and then rounding to the nearest integer.
Table 11 Restrictions on specifiable characters for property values of filter condition expressions
Characters that cannot be specifiedProperty name
• A value must be specified.
• If multiple values are specified and separated using commas
(,), any spaces at the beginning or end of the ArrayGroup
names are ignored.
ArrayGroup
CLI Reference Guide 49