HP P9000 Command View Advanced Edition Suite Software 7.2 Installation and Configuration Guide

B Ports
This appendix describes the ports used for P9000 Command View AE Software.
For a complete list of system requirements, see the HP P9000 Command View Advanced Edition Suite
Software Release Notes.
P9000 Command View AE Software server ports
Ensure that P9000 Command View AE Software ports do not overlap with those used by other
programs on the management server.
Some ports can overlap with ports temporarily assigned by the operating system. You can stop ports
from being temporarily assigned by setting the ports in the operating system services file.
These ports are described in Table 22.
For more information, see the HP P9000 Command View Advanced Edition Suite Software
Administrator Guide.
Table 22 Port numbers used by P9000 Command View AE Software
If the port is in use by another productDescriptionPort Number
The settings cannot be changed from Device
Manager.
Change the settings for the product that uses
this port or follow the message that is output
during installation to disable SNMP trap
reception.
Device Manager ports
162/udp
Change the settings for the product that uses
this port or change Device Manager settings
before starting the Device Manager server.
If another product is using this port, the
following message is output to the event log
file and Device Manager does not start:
KAIC00114-E An attempt to start
the HTTP server on port
"port-number" failed.
2001/tcp
2443/tcp
Change the settings for the product that uses
this port or change Device Manager settings.
5983/tcp
5988/tcp
5989/tcp
23055/tcp
Change the settings for the product that uses
this port or change Tiered Storage Manager
settings.
Tiered Storage Manager ports20352/tcp
Installation and Configuration Guide 81