HP P9000 Command View Advanced Edition Suite Software 7.2 Installation and Configuration Guide

+ value-for-Tiered-Storage-Manager
+ value-for-Replication-Manager
+ value-for-HiRDB
• All other kernel parameters and shell restrictions:
kernel-parameter-value-to-be-set =
Max{
Max {
value-that-is-enabled-in-the-system
,
initial-value-of-the-OS
}
+ value-for-Common-Component
+ value-for-Device-Manager
+ value-for-Tiered-Storage-Manager
+ value-for-Replication-Manager
,
value-for-HiRDB
}
NOTE:
Max {x, y, z} indicates the maximum value among x, y, and z.
Related topics
• Setting kernel parameters and shell restrictions (Linux), page 22
• Recommended Red Hat Enterprise Linux /etc/security/limits.conf values, page 25
• Modifying kernel parameter values and shell restrictions, page 30
Recommended Red Hat Enterprise Linux /etc/security/limits.conf values
Before installing P9000 Command View AE Software on a Red Hat Enterprise Linux system, set the
shell restriction values for the /etc/security/limits.conf file. Set the shell restrictions for soft
and hard settings.
NOTE:
The soft value must be less than or equal to the hard value.
The values for these settings depend on which of the following P9000 Command View AE Software
products you are installing:
• Common Component
• Device Manager
• Tiered Storage Manager
• Replication Manager
Installation and Configuration Guide 25